peaky1979's latest activity

It has 3 wires going to the plug but there red blue and green now when i got the car they were black red and blue and the black 1 was disconnected so i replaced the whole lot back together but like i say the obd reader doesn't pick the fault up

Its a 2006 range rover sport hse 2.7 tdv6

Hi mate it doesn't move at all it just stays the same fully down. I have done a collaboration myself as my obd reader does it but it never comes up with a code for the sensor

Just noticed again thats what i said rear passenger wheel in the first message 🤣

Yes sorry i just noticed i said right 🤦🏻‍♂️

Test the wiring with a multi meter, you should have three wires yellow/brown should have 5volts, yellow/black is earth to ECU so you get 5v between it and yellow/black. You also should have continuity between yellow/black and the metal work of...

I just copied what the last owner had done

I have tried that. The last owner had replaced the plug and 1 wire was hanging off so i got a new plug and sensor but not sure if the 3 wires are the right way around

Ive also put a new plug on but its still the same. The suspension works fine it just goes down every night but if i disconnect the battery it stays up

Hello mate Yeh its not recognising it. On the 4x4 screen its permanently down. Ive done a calibration on it with my computer. Thanks

Hello everyone Does anyone know the proper part for the rear passenger side wheel height sensor. I had 3 off amazon and it still wont read on the 4x4 screen Thanks Steve