patrickr90's latest activity

So is it only po So is it only possible to have the instrument lights on at the same time as the internal light. Or would there normally be another switch on the internal light, or is it supposed to just run from the door post switches (which I...

Thanks for confirming. Clearly been hacked about then. I've got the switch but it's unplugged and the wire chopped for the internal light. The wires for the instrument light have been rerouted to run off something else - obviously a permanent...

Mud do a replacement, but it is probably available from other places as well: LINK Depends on the exact wiring for your model but at '86 I would expect it to be permanent live. On later models it was changed to be ignition only.

My 1990 Ninety has both Permanent live wire and a switched one available for the lighter socket. I think how which was connected depended on the country vehicle was sold in.

Thanks all. It looked like such a hacked about hole that I thought it was mostly the work of the PO. But good to know it's alot of the original wiring (albeit I don't have a rear wiper or rear demister). I've got the casing for the radio but...

Hi Just doing some work on the dash on my Defender 90 - 1986 - instrument panel, tidying up etc. There's an outcrop of wiring emerging from the centre of the dash (pic attached) - hole cut through at the back. Some of it probably for the radio...

The part the bulb holder slides into is not replaceable as it’s part of the instrument. I repaired mine recently with the tube of a felt pen and glued it in. I then used heat proof tape round the bulb holder so it was a nice fit. I’ve got LED...

I used Gorilla Glue. The one where you wet the surface and the glue reacts with the moisture. It’s good stuff but I needed to clamp it while the glue set, as it expands and creeps into any tiny gaps. I can’t remember where I got the bulbs sorry...

Nice plan! I'll hunt around for something similar diameter or raid the family felt-tip store. What glue did you use and which LED's did you use? There's a massive choice out there it seems....

I feared as much :-(

Hi all In the process of overhauling the instrument panel which was all bust up. Defender 1987. The backs of all the instruments are missing the part that the bulb inserts into - just a hole - except the fuel gauge still has part of the green...

I know the feeling. Amazing what a few months does to the memory!

Thanks everyone for your advice. ATF it is then! Cheers

Hi, just had a bit of play. Looks easy enough. Thanks for the advice... I've ordered a new cowl as well.

Thats what my left over gearbox oil change is used for. J

Another vote for the cheapest ATF you can get your hands on. Its nothing special.

Anything that's red and says ATF.

You have to take the front off the binnacle - screws on either end and the base. Then the gauges have a screw and u shaped clip thing that has to come off. Make sure you pay attention to the black wire with the eyelets on it, and replace it in...

Personally, I use whatever ATF I can get hold of from Halfrauds.

Hi What's the best, most available, power steering fluid to use on a 1987 Defender - 200Tdi Discovery conversion? Thanks

Hi All Can anyone tell me whether it's possible / how to remove the individual instruments (speedo etc) from the instrument panel. I want to put the instruments in a new panel as the original one was mashed by PO. Thanks

Depends what version you have. Csw would have one SW might. Aftermarket conversion types not worth the hassle, might as well get a scrapper roofing as lining with seals for the sunroof. Most here would testify you be lucky with sunroof leaking as...

:) I might be on that road if I can't get it to stop leaking! Then buy a headlining kit without the sunroof opening...

Yes. Certainly worth a try. It's missing the headlining in the front and I'm conscious that, if I buy one with a sunroof opening, it may not fit.

I've just got some alloy layered to fit flush in the hole on mine (and another with a border to cover the joint on the inside). When I get around to it I'm going to bond the whole lot in and be shot of it for good. (I have a non sunroof liner...

I would seal it up and be done with it. CT1 makes bloody good sealants.

Hi all Just taken ownership of a Defender 90 200TDI - 1987. It looks as if it may have a non-Landrover sunroof fitted (was a sunroof ever even factory fitted into the early Defenders?).....and I've discovered it leaks like a bar steward. The...