Recent content by p3bbillym

Had exactly the same problem as you a month or so ago. Changed the front airbags as they were cracked and worn, refurbed the valve block and the compressor which didnt cure the problem. Rear airbags looked perfect so carried out leak test with proper leak tester and no leaks were evident...

Did them when i first started having problems as i could see that they were cracked and worn...:)

Hi Guys just an update on my recent problems. Removed and checked the height sensors and all were fine. So bought 2 new Arnotts for the rear and fitted them, this has cured my faults. On inspection of the old air bags both were de-laminated and cracked next to the bottom joint, this could only...

Afraid so, squeezed trigger on the spray gun so much that i have got cramp in my right hand. LOL

Thanks guys, will check the height sensors over the next few days. If the sensors prove to be OK will replace the rear airbags and see how things turn out. When disconnecting the sensor/s do you have to disconnect the battery or will leaving a door open be sufficient.

Have tried running compressor with door open at all heights. Once tank is up to pressure the pump stops and then doesnt start again along with solenoid valves clicking until the door is closed at standard height . Thanks again, grateful for any comments and suggestions.

Yes i fitted a valve to the airbag pipework which i removed from the valve block. Will try changing the height on each sensor in turn as suggested. Thanks for your help, much appreciated.

I have tried blowing each airbag up separately and left them overnight. None of the airbags dropped more than a 1cm which i put down to change in air temperature.

Hi TCubed thanks for replying. Just checked her in low (access) position and the pump stays off the same as the extended height. Havent tried her in crawl.

Hi everyone, new to P38 and have checked posts for this EAS fault but i am unable to find this specific fault. Would appreciate any help or suggestions EAS height changes work fine and quickly. No faults logged on EAS unlock software New air bags on front and I cant detect any air leaks...