Recent content by p38Lover

No I haven't checked the orange wire yet but it was ok when I put it all back together

it willrun no problem with the laptop so it cant be the brushes can it ?

No there is no leaks i can put it on the high setting and it will stop up all week not started or anything dont think i will get any tee's day looks like my miss will be sat with the laptop on her lap today he he

Right thanks getting a bit sick of it now think i have sorted it then it dose it all over again is there any way i can bypass it for now cus my miss wants to nip here there and evey where just till i get a bit of time thanks again

hi just want to update eveyone i have replaced the thormo switch and it worked no problem for a good 5 hours and then its all back to not going up compressor not coming on unless i plug the laptop in and use the eas unlocker softwear !!!!!!!!!!!! HELP !!!!!!!!!!!

ok i will have a look thanks again

where would that be found thanks

i have read the faults and it came up with 1 saying vehicle has moved but i cleared it and no faults came up but when i unplug laptop from the car the pump comes on for a second then goes off :confused:

i'm looking for some advice again my range rover p38 1995. the eas pump wont go up and not showing on the dash. I've got the easunlock software I've plugged it in to the car and i can switch the pump on from the laptop but when i disconnect it it still wont go up any ideas will be much appreciated.

yes i was on level ground and thanks

Hi are these the right setting for a range rover p38 1995 dse tyer size 255/60/18 All from centre of wheel to wheel arch lip. Access 405mm. Motorway 445mm. Standard 470mm. High 510mm. :confused:

yes will do and i have set all the ride hights are these the right settings i have got them off here. All from centre of wheel to wheel arch lip. Access 405mm. Motorway 445mm. Standard 470mm. High 510mm.

got it sorted thanks to the help from here :5bhurray::5bhurray::5bhurray:

got it sorted bit of sh@ stuck in the diaphragm i have ordered a full seal kit to do the job thanks for the help

ok thanks just on ebay now then going to get it in bits