oneofakind17's latest activity

Yeah said that on thr attachments sent earlier I don't think mine has external pressure relief valve

It got up to 12 somat i was busy playing 🤣

Al little video look at resobmvoir pressure that show how its filling up and tell me if u think that's too weak

Is their a way i can upload a video on here

I have been looking a new compressors on Ebay range between 120 and 250 but all of them don't say they will fit the td6 :/

It does take it a few cool downs to go from 0 bar to 13 bar

I just lifted it up yeah its to 100 degrees max and shuts off I can't recalibrate now till its below 50 just left it running atm build pressure back up in the tank

So that's what its currently saying which is better then it was

It does tell me from the rim and yes I put it in from each corner

May I add i could only calibrate for 20 inch wheels not 22s it would not let me put higher then 800mm or lower then 680mm

Right so tried to recalibrate height and didn't matter what mm I put in it did nothing 🤣 Yes all doors were shut and it was running And i also turned off after and restarted still showing no faults on dash

Right so after messing for a few hours manged to get it aired up But its not level at all can't see any leaks or hear any however I've noticed 2 main thing that I think shouldn't be like they are According to the scanner ride heights are as...

Slowly getting there

Replaced fuse cleared the code and its started doing it on its own

Not quite I'm omw back from work now lmao so I'll put fuse in etc recheck volts will keep u all updated

Is anyone able to tell me from floor to wheel arch height of normal height mode with 22inch wheels so I can recalibrate the height

For reference the Merc Wabco I use on the bench takes about 2-3 mins to fill a 5 litre tank. So running your compressor & seeing only 1.6bar then it probably needs a rebuild. To be sure run it for 5mins manually & then check the pressure. If...

Yeah I read that I'm gonna put a new pressure sensor in the the tank and see if that makes a difference

Well think its fubarred will get one tomoz and retest

Will check in a min

Tbh I don't think there is a leak and it builds pressure pretty quickly for a small compressor so wouldn't think it is at fault but still a possibility Ill start with no power situation get that fix then try everything else lmao

wright so air compressor relay clicks like its supposed to but pin 3and 5 the ones your supposed to bridge to bypass relay neither have voltage Any ideas where to start looking lol Put a 12v feed to compressor and it works left all other wires...

Thanks will do Wen I'm home from work I will volt test relay and power wires will post results

No not when I had it running yesterday compressor was dead but I have inflated bags in the past off a autel scanner was able to run compressor I'm 100% if my launch scanner can just run compressor seriously debating spending 160 quid on a...

Sorry forgot to take a pic live data said tank was at 2.7 psi which is obviously too low and I can open all the valve on the air system they all appear to open/close through the scanner but nothing i tested let the compressor run so I'm thinking...

So scanned tonight on a launch scanner Could access eas and do some tests but not active the Compressor I've attached some pics of what I could access any ideas

My location is Burntwood ws7 I will get my pal to come down again will check live data

Dunno what version it is but connect yo sys fine I was able to run tests but no code were showing it's a 2024 version with active subscription so it's up to date should be for 4.5k

Light on next to air ride is on the - if u set to raise it just flashes No touchscreen it's a 2002 it's on bumpstops now last time scanned and raised was about 2 months ago