Recent content by oldford

Not having a lot of joy with this pump everyone I buy has to go back with a problem,I've just been told that one off a 2005 0265225059 will fit mine which is a 2003 0265950056 can anyone confirm this as I'm sick of wasting money sending them back Thanks guys

in answer to previous question regarding (has the vehicle been connected to diagnostic software) yes it has and unfortunately has no comms with abs module. it wil communicate with all other modules, what i am trying to work out is, as there are slight variants in the part numbers, is it that...

Hi guys again I just had a replacement unit fitted ( second hand) and the abs light is still on ,the numbers on both units are 0265950056 but on the barcode label there are 6 numbers that are before that number which are different is that going to make a difference or could it be the new unit if...

Thanks for that will give them a call

Thanks for that ,was that complete with the ecu and do you have a contact number or link for them

Hi guys I have a 2003 l322 v8 petrol range rover. My abs unit is faulty and was taken off by a garage and sent away to be reconned but was sent back saying un repairable at a cost of £75, symptoms are abs light on power steering gone heavy , speedo stopped , light on and brakes gone hard so...

Now we all know why he's called the Saint ,both motors seem to be seized so I just pulled the fuse and the buzzing has stopped . Will charge over night and take a spare battery and leads in boot for awhile just in case . Thanks again saint

I have a 2003 l322 range rover. This morning I had a flat battery which seems to happen every couple of weeks when weather is really cold . Well I stuck a charger on and used the mrs car and went to work about 3 hours later she rang me saying there was a funny noise coming from the range rover...

Yes it is sorted,there is a clip on the end of the cable that came off.have pm d you to let you know how

Anyone know if its possible to use one of those slides you put down between the glass and rubber to open the door (like the police and car thieves use) before I start grinding the door handle off or is there a plate of some sort stopping that happening.

Ok thanks guys,now I can hope for a door handle in the old stocking in the morning and not socks. Have a good one.

So if I use an angle grinder to cut the handle off then I should be able to get to the lever etc to open it ? At least the handle would be cheaper than a door card and less work . Thanks guys

Thanks for the help guys ,but how do I get the door card off as the dash over laps the door which would stop me getting it off with out bending the hell out of it.

I have a 2003 l322 vogue.the passenger door won't open all other doors work fine on c/locking and they also work with the button on dash,the button on the door also goes up and down ,both inside and outside handles don't work and have no resistance when trying to open . Anyone got any ideas ? If...

I have a 2003 4.4 on a gas conversion which has an annoying miss when going up hills mostly ,which causes engine management light to come on and gives a code P1300 and multiple misfire.You only really notice it on gas not petrol,I have changed the plugs and its still there .I had the gas checked...