Recent content by nigglyblue

Any ways, nice hijack. I have stripped down inlet manifold, erg valve and cleaned them thoroughly. Cleaned out sensor spigot entry hole and put back together. I noticed that there was a rattle type noise and found that the jubilee type thing was not meeting up and therefore allowing boost to...

No mate all is well on that side, just the juddering and poor acceleration.

Not as far as I am aware, haven't really looked to be honest.Damn it! Something else to look at.

Don't think it is plastic but will have a look and see if I can gunk it. Thanks

Thanks Datatek, I did not get around to cleaning up the entry port for the sensor spigot to go into. I am removing the inlet manifold and egr valve this weekend and deep cleaning them, do you recommend a product to clean out the spigot entry port on the back of the engine. I am going to gunk...

There is no pipe to the sensor but i did not check spigot entry good point will do that tomorrow. Thank you

Hi guy, My l322 vogue td6 2005 has developed a judder at idle and on acceleration after slow down. Holidaychicken put it in allcoms and pointed to map sensor, which I have changed but is still doing the same thing, any ideas? This is getting ridiculous drove back from Norfolk like it, lucky...

Thanks Gold rover will give it a try.

I'll look at these tomorrow and let you know.

Ok mate thanks. I know the thread you are referring to. Wondering about the inertia switch as well. I am working tomorrow night but I will rise early for another battle. Just had one with the Mrs about that b****y car, so just about ready for it now. Look forward to you suggestions of things to...

Hope not just had gearbox reconned. Might have to recover it to Maidstone RR specialist.

Thanks Goldrover, Yes Holidaychicken did say he had Allcoms but I believe he had not uploaded td6 module. I will take your advice. Thanks again.

Guys Just so that you know, haven't had a chance to look at the car as I have started my night shift, 12hr shifts, great. Won't be able to look until Wednesday, I'll keep you updated. Really need allcoms but will persevere. So much agro getting to a sensor and then that may mot be the problem...

Thanks Saint, hope he sees my post.

Thanks Saint any idea where the sensor is?