Recent content by [email protected]

No I didn't know about the down pipe, where are they from ?

Was my post of any use pricey ?

Aint I the cockey one, I use paddocks all the time with no problems at all, but then again I only live 10 minutes away, lol. Nick.

:cool: Where do I begin ? I have a 200 Tdi out of a disco in my series 3, and there were quite a few obstacles to overcome, :- in order to keep the series 3 front end, I did away with the viscous fan and fitted a kenlow push fan that I put in front of the rad. :- I used my series rad, as it was...

:cool: So who's going to Driffield this weekend ? I am but unfortunately in a VW passat not my landy, well not this year anyway. Nick.

try paddocks landrover website

I've recently put a 200tdi out of a disco into my series 3 I didn't use the disco rad which incorporates the oil cooler, I nw need to fit an oil cooler, I have my eye on one from flea bay but I'm not sure what thread size I need, I've got the pipes off the donor disco coming shortly I've been...

I,ve got britpart on my 88" and they're fine, looking at your picture it looks as though the spring hanger is slightly bent, when you fitted them did you lower the motor prior to tightening the nuts, which is what you should, I didn't and end ended up with the car about 4" higher than it should...

My advice is to treble check that you have connectd the arial correctly, both at the antenna end and the cb end, are both the antenna end and the cb properly earthed, if you have a mate ??????????? with a cb get them to sit quite close and keep checking, if you can pick them up, but no one else...

Cheers M8, great advice, shame you don;t live closer Nick.

Thanks for that, thought I was going to have a big job on, saved me loads of time thanks M8 works a treat, Nick.

That sounds like really good advice, I thought it may be something to do with the slave cylinder, but the mechanic tried to steer me away from it, today I think I know why, when I went to remove the slave cylinder the bottom bolt had been cross threaded in the bellhousing body and thus was not...

Went out laning last week and had a right to do with the brake pedal, firstly the brake light switch disintergrated, then the pedal kept sticking down, I gave the pedal box plent of WD40 but still no joy, the retun spring is fairly new so can't be that, has anyone any advice on what I can do...

How do I change my user name from my e-mail address to the one I've chosen, or is my e-mail address user nameonly visible to me ? Thanks, Nick.

Please any help greatly appreciated, especially Teflon, I have recently had a 200tdi fitted onto my standard series 3 box, at the time of instillation I also had a series 3 clutch kit fitted, and put a fairey O/D on as well, when I'm in 4th and try to accelerate it spins also in 3rd when using...