Recent content by nee

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. N

    injectors to clean or not to clean??

    hi, got a freelander 1 2.0TD, Thinking of taking out the injector's to give them a good clean, there doesn't seem to be a problem with them so is it worth taking them out? or will a fuel additive do a good job? if so got any recommendation's.
  2. N

    Not another EGR question!!!

    hi, check out the thread 2 stroke oil in diesel on page 2, it may be of some interest!! :)
  3. N

    Egr Blanking Mod

    that's what i was worried about, so will definetly flush out and leave as is. THANKS
  4. N

    change a heater matrix!!

    why do you need to change it? only my heater on the 2.otd is rubbish, but the problem seems to be the routing of the pipe work. so if it's had it then carry on. but if it is just not working very well check your pipe work. just a thought before you start!!!
  5. N

    Egr Blanking Mod

    no, got the freelander 1 2.0td. the egr fitted to the exhaust manifold has the vacuum valve, then goes through the egr which has a heat exchange in which i assume cools the exhaust gas before it goes back to the air intake. so just thinking that were it is on the manifold with no /little cooling...
  6. N

    Egr Blanking Mod

    hi, if the egr is disabled but left in will it still need cooling?? only read about a guy who rerouted the pipe work so the egr and heater matrix were in series instead of parallel which increased the heater output in the cabin alot. so thinking while its stripped down i might restrict the water...
  7. N

    2 stroke oil in diesel

    hi, going to give my freelander a go on 2 stoke oil, so what's the general opion on diesel / oil ratio thanks
  8. N

    ird

    hi, anyone got a good tip on how to remove the heat exchange on the freelander ird without damaging it. other than skip it and get a new one?? or just any tips on how to remove it. THANKS
Back
Top