Recent content by nan-ber

Bit of a delay getting back, but the plastic bottom of my rad was leaking so I had to bite t bulleti and get a brass one made also, however all's well so far , new 4core copper and brass rad is fitted, and I took wammers advice by going with the viscous fan, temp gauge sits half way on a hard...

Cheers wammers, so do you think I should go with an even lower switch say 90/85 , and I presume I can connect it into the black/blue wire close to t tri nary switch and this will turn on the fan through the relay, without any ill affect

Just to update, new rad being built , unfortunately I ll be using my old plastic bottom , not really what I wanted but needs must at t moment, however new 4x core in copper and anew top tank in brass with a tapping for the Thermo switch for the fans, now has anybody any idea what temp switch to...

Sorry , it's a DSE , if I remove t viscous fan and use datatek s tip for aircon fans for cooling I won't need t shroud, guy can put a tap in t rad for a temp switch and he thinks he'll be able to put a pipe up along t side to meet the top hose , reckons €400 will cover it , rads here vary...

Water pump failed last week taken t rad with it , have a guy who ll built a copper core rad with brass tanks , would u change t flow of t rad by putting a pipe from t bottom up on t outside , would I t b a good idea or not and forget t complications of t baffle and t u design flow of t normal rad ,

as always guys thanks, you were spot on thermal switch gone, but i think i lost fight to keep her off the coils, 2 sensors a comp seal and a thermal switch and he s changing, fear of the unknown, but at least i ll get to drive a coil conversion and compare. let it begin ha ha . thanks again

thanks wammers, owner wants 2 convert 2 coils and i m trying to stop him, he dont want to pay to maintain the eas but no prob to pay for the coils ha ha , funny ole world

but would the pressure switch fault show up on the eas unlock, am following that thread at t mo also, i have shutdown the eas unlock correctly , this is the first time i ve had any following issues. i thought that the compressor could not run if the thermal switch had cut out even with the...

a friends 38 00 dse threw up eas fault, i cleared the faults this eve, how ever the compressor wont run unless i tell it too, anybody got any ideas,, thanks

done mine as per rr.net, 4 hours and 2 euro for the rings, had a right angle drill from lidl that done the job, put back a hex head m5 thread if i remember correctly, not a huge job, go for it

ya solenoid can be heard clicking but locks wont open, hazards flash every time, and then t interior light comes on and she s open, and just like the wife ,but i wont always peace or no peace so i ll fix her hahaha.

i thought they should last longer than i was getting, but t cars acting funny, in that sometimes it wont open , you just keep locking unlocking and then she opens, any ideas data,

tell me folks , how long should the key batteries last.mine only seem to last a couple of months as in fitted a set last october and she s telling me their low now , does that seem right.

lost the battle spud, herself bought 2 day on ebay so that s that, tell me ,how do you make sure the barrell is lined correctly.

thanks lads, just one more question, wheres the best place to get t parts, checked out rover renovations and they have a stainless liner, is this t way too go.