Still got a problem 🤬 still got a vacuum on the bleed screw I’ve cut 5mm off the bottom of the pick up pipe seems to have worked so far. It’s now pumping fuel out of the bleed screw off for a test drive via the pub so if it does pack up at least...
Hi everyone first of all i want to thank everyone who has been helping me out with my problem I have finally found the problem 🙄I replaced all of the pipe work still had air coming in from some where. I put a small rap of ptfe tape on the inlet...
Yes I thought so I’m getting hardy any fuel coming out when I hand pump it as it’s probably on the wrong place on the cam, but when the engines running I’ve got plenty of fuel coming out
I’ve seen on here that you can fit the lift pump wrong side of the cam? I have just unbolted the old one and put the new one in and tighten it up is that correct?
No it’s just one unit sender is half way up the pick up pipe I’m going to start again tomorrow morning and go through everything SLOWLY ONE THING AT A TIME. 🤞🤞
Next thing to do tomorrow as we have gone through everything else it’s always the last thing you check hopefully I’ll find something tomorrow morning will keep everybody posted
So I’m I 😂😂yes and straight to the injector pump I’ve tried so many different things I’ve forgotten what I’ve done had help from a great mate so I think we’ve only got the pick up pipe in the tank to check but that’s only 2 months old had...
Hi Steve thank you for your message I’ve put an external tank on the system with a in line filter and it runs fine. Going to get some clear pipe tomorrow morning and start working from the tank backwards to the injection pump hopefully that will...
Yes I’ve filled up the filter with fuel and it’ll run fine for a few minutes it’s like the lift pump is not working but I’ve taken it off the engine with the pipes still on hand pumping it with the cam arm fuel coming out of the pump no problem...
Hi all today I have fitted a new lift pump new pipe work took out the plastic spacer and replaced it with 3 gaskets as per the video I removed the drain plug on the fuel tank and noticed that the diesel was not coming out very fast removed the...
No just welding I’ve had it running with the bleed screw out but no fuel coming out of the hole. Turn the motor off and hand pump the lift pump and i get a good amount of fuel out. I’ve put the plastic spacer in ? Is that correct as it’s never...
I’m going to try that next I’ll get some decent pipe and replace everything. New copper washers check everything that I can think of. Thanks for your advice 👍👍
Hi Anaconda yes I’ve checked the solenoid all good
It’s a brand new filter. I can only think it’s getting air in there some where. But with a full filter it will run fine until it drains the filter.
Hi lynall thank you for your reply. no recent work done recently The problem started after having my Land Rover back from being worked on by my mechanic. I did actually tell a Cornish man there was no rush and do it directly. If you ever been to...
Hi guys, I have a problem with my 200 TDI. I have replaced the lift pump as the engine would only run for a couple of minutes and then it would die. I’m trying to restart it with belch white smoke which I think is under fuel when I bleed the fuel...
Hi guys, I wonder if any can help me with my 200 TDI will not run for more than two minutes then starts belching white smoke under fuel. I think I have changed the diff pump and a new filter all the returns from the injectors I have replaced the...