mikkre's latest activity

Maybe I explained poorly, If I change the ECM, and if it doesn't work, I don't do anything. I exchange the old one back, does it work as before the exchange?

Can I start the car if the oxygen sensors are disconnected? I was just wondering what readings I would get with the bridge's Ican tester

Thanks for the answers! If I change the ECM and it doesn't work, will it work like before if I change the old one back, that is, will any settings change if I change. I've ordered the NCOM05 but it won't arrive until weeks later. Oxygen sensors...

I break the "radio silence" I measured all the wires of the oxygen sensors with a resistance meter. Everything OK. Power and ground connections connections ECM are ok. I think there are two possibilities: the ECM is faulty or the oxygen sensors...

I have done obd testing three times, almost the same result every time. Does this Icarsoft LR v2.0 give the correct readings?

Yes, there is even a comma there: A 317.50V varies little, B: 318.76V varies little.

Those bank A and B readings first wandered recklessly between 1.5 and 317V both, the connectors were oily, I now shook them with a degreaser at first. After cleaning, the connectors looked good, no oxidation. The readings given above are after...

Hello experts, would you be able to help with these readings, taken with an Icar v2 obd reader. Bank A : front oxygen sensor voltage 316- 317V. Bank B: 320V. O2 sensor heater 15.06 . Oxygen sensor average 46592%. Also gives a new fault code...

It snowed approx. 7 cm and it is 4 degrees below zero. No repairs today. I have an extra 270W solar panel. I think I'll put it on the wall with the controls and cable from it to the car plug. I defend the 270W panel, it might produce enough...

OK, thanks, I'll get one.

Datatek, what kind of solar cell do you use when the RR is not in use?

No problem in EU countries, but if I order from England, customs and taxes will be added

I'm Erkki, I've already seen my best days, empty pocket, city Jämsä, country Finland

I had the ECM open a while ago. Under the plastic protective cases they are indeed on stands, not soldered, also this ERR-5760 which is from my car. There is also a third chip, which is just pressed into its slot, exactly square, the size of a...

They are plug and play, you just need to be careful, they say. I would still have to pay freight, customs and possible VAT.

Now that I've browsed the sites ECM (ECU) upgrade Chip Would this also seem to be an alternative solution to my problem? For example, Britpart publishes a 3-page guide to replacing chips. If my problem is precisely in those chips, would it go...

I came across the Tornado site online, which has some kind of tuning chips that promise better fuel economy and other "advantages". I understood that the chips would come in place of these chips that I have written about, and which may have a fault.

Yes, the M27C I mentioned.... are in a separate "foot" to which those chips are simply pressed. At least in these two AMR-5499 boxes. They are under the green and blue protective case.

Those memory chips are replaceable without soldering, that's where my idea of a possible replacement with a chip borrowed from another ECM came from. Why would you have bothered to do without a soldering iron... When I solder semiconductors, I...

thanks everybody! Printer for that 4.6. I have to read carefully because my language skills are limited.(=bad) If I hadn't connected Icarsoft V2 to the obd port and read the fault codes, I wouldn't know anything about this fault. The fault light...

Focusing; Are we talking about ECM or BeCM boxes? I easily get confused in these abbreviations. I myself have tried to talk about the ECM box where the error code came from.

I explained badly, I didn't put new ones, but similar ones from another ECM box, I have 3 of them, all from the same car..

I measured the battery voltage: 12.6V, so the battery can be accepted? If we start from the assumption that the ECM memory is damaged, as indicated by the fault code P0605. Am I right, the memory is one of the two 32 pin microchips under the...

The alarm isn't really a problem for me, I've told you about various malfunctions here. The alarm does not sound because there is no alarm siren at all, just an open plug. The light effect is visible. I saw that a short-circuit has been made...

This is originally from Germany, brought from there used to Finland

Some "additions" have been made to the wiring in the car by the previous owner, but they are probably related to the locking of the doors, at least the tailgate opens from the outside handle even when the alarm is activated. Triggers an alarm. As...

I live in Finland, in the city of Jämsä. I have our company website www.verhoilijamestari.fi if you are interested. I don't speak English, I work through Google traslate...

I don't have Ncom05, my friend does but he is traveling. I have Icarsoft V2 with a p38 partition, I have removed the error code with it, but it is back when I look at it another time. I am now talking about the P0605 code. It also shows P0183...

These pumps are frozen and cracked. I already have the new ones.

I don't know the EKA code, and neither does the previous owner. Is there any way to find out?