Recent content by Mikey-b

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. M

    Loud noise at 55mph+ Disco 2 td5.

    *Bump* Was this issue ever sorted?
  2. M

    Clutch troubles!

    Please excuse my ignorance! But when you say arm, do you mean the fork bit that pushes against the thrust bearing part? I'm guessing it's a gearbox out jobby :( Are there any illustrated guides to this anywhere?
  3. M

    Clutch troubles!

    Noticed my clutch was very hard to depress yesterday, then this morning there was a little travel in the pedal before engaging the clutch, then more an more until the pedal travels down to the floor an springs back up to the top with no resistance. Have taken the Master and slave cylinders off...
  4. M

    Loud clacking noise, but not in 4th gear!

    Hi, I was driving my Disco 300tdi with a heavy trailer on the back and it started making a loud clacking noise but only when the clutch is released and in gear. It doesn't however make the noise in 4th gear, which I found strange :confused: The noise got quicker as my speed increased. I was...
  5. M

    Little switch on lock barrel.

    It must be broken because I've not seen any special flying monkey rescue squads!!! Would this signal it sends happen to be an important one?
  6. M

    Little switch on lock barrel.

    Does anyone know what the little switch on the drivers door lock barrel does? It activates when you turn the key. I was removing the assembly to fix the lock and the two wires snapped off (unless they were already snapped and it doesn't do anything!).
  7. M

    300tdi remote locking or not?

    I bought an M Reg 300tdi but it didn't come with a remote key fob, but it does have central locking, the guy said it never had one when he bought it. Is the fob missing or did some Discoverys not have remote central locking as standard? If the fob is missing, can I get a replacement? and does...
  8. M

    300TDI troubles.

    Fantastic, just fired it up!! The clearances were way out, that must have been holding the valves open when it needed compression. Thanks a million for your help. I'm a very happy bunny! Mike
  9. M

    300TDI troubles.

    I'm new to this site so would just like to say hello to everyone :) Please excuse my lack of technical knowledge, I'm not a mechanic but have messed around with engines before and know my way around them enough to have taken on this project myself, I know what most things in an engine do but...
Back
Top