Recent content by Michael Gentry

Thanks wammers. I have ordered a kit and will try and see what I can do.

Hi all, My 99 p38 is dropping overnight on the one side only and down to the stops. Appears that the pressure tank has lost air as it takes a fair while to pump it back up to ride height. I have checked the airbags and look good and clean. Have sprayed all the joints I can see and have no air...

I was stupid and checked how much one is. Ill be looking at cleaning it tomorrow and being very careful. Is there an excepted way you do clean them. I have a google search and haven't found anything other than people saying they cleaned it.

Thanks Wammers. I have just read a post on here that pointed to the XYZ switch. Next payday ill get a new one on and see if it cures it along with some adjustment. I'm so glad I like projects.

Thanks for all the help. It turns out it was a bad ecu. New one plugged in and all is working. Except it will not select drive properly so another thing to keep me busy.

I have completely disconnected the abs ecu and nothing changes. so I'm leading to the ECU like you said. I'm not really good with electronics so testing the loom other than visual is going to be a big challenge. Sadly I need to wait for payday before I can get a replacemtn so ill update when I...

As a further update. i had a look at the rings an they looked a little rusty but not too bad. ill get to clean then at the weekend now however the lights and warning have gone out. So i no longer have any warnings and faults on the abs ecu but i still have no speedo.

I may be black flagged for this but I quite like the Cherokee haha. That sounds apt. the underside isn't the cleanest I have seen. plenty of surface rust around the hubs. Mike

I have just taken the range for a drive to see if any faults return. Only the EAS had a fault and that was the ecu couldn't get a road speed. The ABS has no faults stored. The following are shown on the Nanocom for the ABS Sensor voltage on all four is 4.91 volts wheel speed (km/h) is 1.7 on...

Thanks for all the help so far. I tested the brake switch and its all working good. It switches everytime I press the brake pedal. Its a new one anyway.

Sorry it Tue written abs and traction failure I get despite having no faults to read on the nanocom. Im sure if I go for a drive they will return however I'm stuck trying to figure out why I'd still have a problem and no faults at the moment. I'm trying to figure out if I could be a bad ecu as...

I have re seated the block connectors. any i can find cleared the faults anyway. Now the system is showing no faults on the abs module however its the showing no abs, traction which I would have thought would go away until it finds a fault when the car is driven?

Ok checked the relay. the ABS pump wont run on with it out but will when its plugged in. Also checked fuse 3 and its not blown however it has an oily residue on it.

initially all connectors look to be in good order within the cabin to the ecu under the drivers seat and the abs under the footwell. Visually I cant find anyting amis. Ill look further. However looking at the black abs relay it has blown up a little(the top as separated from the base. I have...

Awesome ill go for a good look. sadly great eyesight isn't known in the family. Thanks for the help