Recent content by mflynn1971
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
M
Thanks for the pointers guys. The drivers side front inner CV and boot is knackered.
-
M
Hi Guys
Looking to buy a front RH inner CV joint , wheel bearings and shocks. There is a massive difference between Original, OEM and Aftermarket Parts from places like Rimmerbros. Are the aftermarket units up to scratch.
Regards
Mike
-
M
Thanks fro the responses guys. I was away and didn't see them till now. Freelander has been mostly parked since then.
Prop is attached, mileage is about 110k. Its strange that i almost imagine that it comes and goes as well.
I still suspect the drivetrain. But i have a slight suspicion on the...
-
M
Hi Folks.
I have a 2005 TD4. For the past week or so I've noticed alot of vibration coming through the car in 4th and 5th at about 50 mph upwards. Its worse on acceleration, less noticeable with little throttle and not there once clutch pedal is down.Its seems ok at lower back road speeds
It...
-
M
Thanks guys for all the quick responses. You might be right about the DMF not being too troublesome on these. And they do get some abuse towing caravans and horseboxes etc. Even in 30 pages of the "Freelander faults poll" it gets only one mention.
One the other hand so far I've seen two thumbs...
-
M
Hi Folks.
This is my first post but have trawled the forum for a while. I have a 2005 TD4 (100kmiles) and the clutch bite is low and is slipping occasionally when i floor it in a higher gear. My mechanic has a few clutch + flywheel quotes for solid and DMF. There is nearly £300 in the...