Recent content by Matt Perkins 3.9

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. M

    Series 3 brakes

    Hi yes it does if you pump pedal you do get a bit of a pedal and it will hold but as soon as you let go and push back down again it goes straight to the floor there are 3 bleed nippels on each front calipers one either side of the pads and one at the bottom seems the pedal will only go to floor...
  2. M

    Series 3 brakes

    Hi got a series 3 on Range Rover axles with the dual braking system but I can't bleed the brakes not sure if the master cylinder is leaking or if I've piped it up wrong. I've got a master cylinder off of a discovery which has the 4 ports as you look at it the 2 on the right I've sent to the...
  3. M

    Series 3 brakes

    Hi got a series 3 on Range Rover axles with the dual braking system but I can't bleed the brakes not sure if the master cylinder is leaking or if I've piped it up wrong. I've got a master cylinder off of a discovery which has the 4 ports as you look at it the 2 on the right I've sent to the...
  4. M

    Dual braking systems

    Dual braking systems
  5. M

    Series 3 conversion

    Thanks for that got a set of defender wheel arch extensions offered them up marked them and cut and folded the aluminium they fit nicely and its sitting a lot better now just need to cut the wings then get them painted
  6. M

    Series 3 conversion

    Hi used a 88" galvanised chassis it's been quite a challenge to get the axles to fit but there on and to squeeze the engine and gear box in plus had to make to power steering box fit. I've bought some wheel arch extensions going to put them on the series tub of I can what the differences with...
  7. M

    Series 3 conversion

    Hi there in looking for some information I have a series 3 I've put a Perkins engine and Range Rover gear box in it and put RangeRover axles on it the problem is the tub doesn't fit and neither do the wings just wondered if any body else had done this? Thanks Matt
  8. M

    Series 3 conversion

    Hi there in looking for some information I have a series 3 I've put a Perkins engine and Range Rover gear box in it and put Range Rover axles on it the problem is the tub doesn't fit just wondered if any body else had done this? Thanks Matt
Back
Top