Recent content by martoke

thnx for that all helps

cheers for that and your help all working well now

thans for input, spent this morning finaly sorted, unplugged all the leads bus to becm and battery hooked up the nanocom, and all codes appeared reset the eka to the original 4 digit writ settingt o becm and went into disarm and doors poped unlocked and started up 1st turn of key.not sure if...

thanks for that yes i have already seen this, ill have a chat with marshals tommorrow cheers for all help

understand can only tell you that in the box i have i can write to the becm this is the two options i have and they have in th epast allow me to change and use new codes for eka i have written page 13 of this link shows it is possible on this site for namocom...

also in options on box show car as lhd manual & lang as french an gems again reset to rhd auto & english edc & writ to box it shows as writ then power down box and power up again and it say its lhd and french etc not sure whats goin on so i reattahced rf lead and have all old codes not sure of...

got to do this in 3 emails sorry Yesterday car went into lock down attached the nan box screen was dead found 5 amp fuse blown in car replaced nam box worked, tried to disarm nothing, went into the settings it is has teh imobilzer code but where the eka code is and teh key fob code is its blank...

hI mozz, heard your the guy for this hope you can help, I have a 2.5 diesel auto range rover edc had some prbs battery drain last year so disconnected rf blue lead an used the key in door to unlock generaly no prob then sometimes if i opened drivers door before the central lock had opend all...

hI mozz, heard your the guy for this hope you can help, I have a 2.5 diesel auto range rover edc had some prbs battery drain last year so disconnected rf blue lead an used the key in door to unlock generaly no prob then sometimes if i opened drivers door before the central lock had opend all...

thanx when i hook up the nam it now says the car is lhd manual and lang is french, i saw another guy had similer prob and he changed to rhd as teh central locking all works from driver door. its possible some on e before has played with the codes becm is in unlocked state as far as i can see i...

yes, crazy thing is i have been using it for about 6 months with the new code i put in and it has been disaming no problem i set it to 1111 and if i got lock out i used the box put 1111 in and pressed disam on box and all doors unlocked and it would start, now all the doors remain locked apart...

hi thanks think im in the pain, yes kept original codes, but found if you use the nanocom there is an option to change the 4 digit eka code and replace it and write it to the becm have done that in the past with no probs in past this time not sure why its not allowing me also further to...

hi, need help from any one with Nanocom box have a 2002 2.5 p38 auto have been using the Nanocom box to get me out of trouble until by new rf ugrade unit, had ususal rf probs and diconnected disabled alarm using nanocom box reset the eka to new number and have been using key to open , no real...

thanks new to site so finding my way

hi, have a 2002 2.5 p38 auto have been using the Nanocom box to get me out of trouble until by new rf ugrade unit, today complete lock out and where i would use the namoco boxto disarm by putting in the eka code at which time doors wouyld all unlock and sngine start now it wont disarm. have...