Recent content by martin c brown

Hi to all I have a Land Rover Santana 1979 108 series 3 and I am in the process of rewiring the dash and front end of it Most of the wiring at some point has been chewed by rats where it has stood for some time I have removed the dash and exposed all the wiring in and behind the dash only to...

Hi all I am having problems with my clutch on a land rover discovery 2 it makes a noise when the engine is cold I think it may be the thrust bearing I also had problem with gear change difficult to get in and out of gear after a long run

I have looked at your pictures but still don’t understand do I cut the metal pipe to fit the kenlow heater flow pipe so that the flow goes through the heater. So it looks to me like I cut the pipe put one hose on one side and the other on the other side so the flow goes through the pump heater...

Hi thanks sierrrafery Where will i find the MAP sensor? It has a new pipe and cat i have ordered new intercooler pipes, And i think i will block off the EGR with the plate and clean the intercooler as well.?hope this works

Hi its been off the road for six mouths,but thinking about it i will change the intercooler pipes and cleane the intercooler as well, the car runs fine.apart from that. see how it gos after

Hi all I would just like to thank you all for your support over my Landy rear rebuild she now back on the road. I have one question driving her on the road is fine,but she looses speed very quickly going up hill or on a long incline. She is as standerd with cat and egr system only because I...

Hi No i have all the documentation and all is fine, but i have put on a half chassis on as the old one was so rotton,and need to put back the chassis number but i dont know the font that was used by land rover used,all i have left is the rivetts where it was i still have the old chassis with no...

Hi all Does any one know wihch is the best way of replacing the rear chassis vin plate next to the fule filtter on the chassis rail, as i am intending to take the car to spain and register it there later this year. has any one been down this road ? Thanks

Hi all I have now ordered a new brake master cylinder so I hope this fixes the problem. I have been doing some more work on the old Landy she is nearly ready for an MOT I have noticed next to the oil filter just to the right is a rubber bung with a clip on it. I think it is part of the...

Thanks again thats got my thoughts going?,will look in to it and keep you up dated

Meny thanks for that i think i will look at air trapped within the modulator in the return pump's circui when the electronically controlled pump is activated cheers

Thanks guys diagnostic tool.i think

Hi, I have replaced the rear brake discs and callipers and I have replaced the brake fluid as well

Hi All I have a 2004 discovery I am having problems with the brake bleeding, I have bled the brakes over and over but can not get them to hold up. Every time I put my foot on the pedal it goes down to the floor. I can not see any air bubbles when bleeding I have read this forum for advice...

Hi Ok I will look into recallibrating systems Many tanks