Mark Piercy's latest activity

What the frig? It's hard to make from RANGE ROVER and LAND ROVER

Not mine.. but saw one at the weekend, bonnet letters were "over lander" Fort it was a bit tacky

UnderPigeon is too hard to space out

Piiiiiiccccctttttures please😜

That's a good tip lad👌😎

Just replaced my bolt @ 168k on 2004 manual. Still in place. Quick tip if anyone has trouble with keeping the sump gasket in place, as it's supposed to be instaled dry, I used thin cable ties through the holes to keep it in place then cut each in...

Remember the airflow meter code you had put up was a historic one not a current issue. I've seen this before on a disco 4. Unless its a current or permant fault don't worry about it. Airflow meter, high air flow is usually an egr valve not...

I dont know the car, but often have a noisey of freds to learn mayb? So I did a little search and came across this on another forum about MAF sensors. true or not I dont know and they didnt mention a fix as the OP was only talking about "were...

+1 brain frazzled. Glad you sorted it. Next person asks this question you’ll know exactly how to help them. Post some pics here and head over to the Freelander sectiob Welcome to LandyZone

Hmmm, that large red wire maybe the battery supply 🤔

An easy way to check, put a multi meter onto a glow plug +lead and with the engine cold turn the key. You should see 12v at the glow plug, if not the relay may have failed or if you can identify one of the leads on the relay as the feed for the...

Anywhere in Europe 👍

Next week I can try.

Yes... some time yes!

I've a client with a D4, it spends a lot of its time doing short journeys, after a run to England and when coming off the motorway it wenr into limp /restricted performance. Due to sooty or unexercised components. I put it on the diagnostic tool...

Does it do a lot of town/short driving?

So the next job began today to change the rear brake pipes from the calliper hoses along with the hoses , pads and discs. Whilst attempting to fabricate replacements for the rear pipes I wondered why they are such a complex shape with tight...

12V (batt +) on pin-1 & 0V (batt -) on pin-3 briefly wathcing which way the window goes. If it tries to go down, reverse the wires. The other pins are used by the outstation & BECM for blockage / trap detection, so you don't need them for...

👍 Crappy link🤬 Take a look on Amazon for an example👍

Welcome to Landy ownership 😜👍

Exhaust condensation is just that as the heat builds up it retaining till being cooled down eventually dew builds up inside the atmosphere of the pipes to settle in pooling. As soon as you start the engine that's what you see spitting out carbon...

You could try a leak off test and compare the returned fuel from the Injectors👍 any more than ten percent and it's replacement time.👉

No, never changed any but had to get them out to replace cam cover gasket. Refitted with new copper gaskets and ensured the bores were spotless before they went back in. Don't appear to have any idling issues or misfires etc, seems to be...

Any warning lights on the dash?

Oooh, didn't you change some injectors recently? This why we change them all to maintain balance 🤔 It does look like you may have further issues 🤯 I've seen values drop under load on a good few cars. The values are for even idle, emissions and...

That only resyncs central locking side of the fob as well. The chip read by the immobiliser is a magnetic chip in the key, no battery power, it works or it doesn't. A diagnostics machine is needed to code it.

the system doesnt hold pressure indefinitely and will energise the pump when it falls below a threshold

Give it time.

Nope, been fine ever since fitted in Dec last year. Only became a problem from last week, I'm not a heavy braker either, quite a sympathetic driver in my own vehicles. It had done about 5500 miles since replacement. Anyway sorted now, new discs...