mantrid's latest activity
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Mmantrid reacted to sierrafery's post in the thread MAF Sensors To Turbo Diagram - Discovery 4 TDV6 3.0 2010 with
Like.
Most probably, they are supposed to be renewed every 105K miles or 7 years according to the maintainance check sheet -
Mmantrid replied to the thread MAF Sensors To Turbo Diagram - Discovery 4 TDV6 3.0 2010.Thanks for the confirmation, okay so I went out, and I swapped out both MAF sensors for two spare ones, cleaned the hell out of the original MAP sensor with brake cleaner and cotton buds then electrical contact cleaner to flush it out and I also...
-
Mmantrid reacted to Nasos's post in the thread MAF Sensors To Turbo Diagram - Discovery 4 TDV6 3.0 2010 with Like.
Correct the A is for the 2nd turbo but if there is a problem with the MAF'S there is a fault code. Without a fault code probably they work well.No A it has 3 wires and No B 4 wires.
-
Mmantrid replied to the thread MAF Sensors To Turbo Diagram - Discovery 4 TDV6 3.0 2010.Sorry, I meant the MAF sensor locations as seen below, I think that the one marked A corresponds to the secondary turbo, so that's the one I need to replace and see if it helps?
-
-
Mmantrid replied to the thread Discovery 4 - Limp Mode Cold Start Manifold absolute pressure issues.Hello mate, thanks for replying, well I was just looking into this yesterday, I get the problem when the second turbo kicks in at about 2500rpm - I had a problem with the air box not sealing right and the elbow connector that the air pipe went...
-
-
Mmantrid reacted to Nasos's post in the thread Discovery 4 - Limp Mode Cold Start Manifold absolute pressure issues with Like.
Hi. P006A-00 is a sign for manifold crash. Do a visual check initiall at the manifolds for oil and do a smoke test. If there is not crash at one of the manifolds, drive you car and check the RPM when you can't accelerate more and in what rpm's...
-
Mmantrid posted the thread MAF Sensors To Turbo Diagram - Discovery 4 TDV6 3.0 2010 in Land Rover Discovery.Hey folks, About to do some testing on my MAF sensors using a diagnostic tool to test the secondary turbo that kicks in at circa 2800rpm, I created this diagram, does this appear right? Thanks in advance, Mantrid.
-
-
Mmantrid reacted to gemsdad's post in the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto. with Like.
Paarrrrrrp.🔊🔊
-
Mmantrid replied to the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto..It's alright I told her it's a 4x4, they've always got muddy exhausts! :vb-lol:
-
Mmantrid reacted to gemsdad's post in the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto. with Haha.
Are you married per chance, be verrrry careful.😂
-
Mmantrid replied to the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto..By not being a thick spastic and putting the tube in the right hole this time! I'm so bloody stupid, it was dark, that's my excuse! :rolleyes::vb-lol:
-
Mmantrid reacted to Stanleysteamer's post in the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto. with Like.
Well tell us all how then so others can know!!! ;) ;) :) :)
-
Mmantrid reacted to Dippypud's post in the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto. with Like.
Hooray, how did you do it, in case someone else asks ?
-
Mmantrid replied to the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto..Scratch this guys, I did it!
-
Mmantrid posted the thread Nightmare trying to fill rear diff with oil - Discovery 4 TDV6 2010 Auto. in Land Rover Discovery.Hi guys, Okay I need some advice, I recently did the front diff oil and the transfer case oil change and all was well, no problems. Then I got to the rear diff oil change, got the fill plug off just fine, and got the drain plug off just fine...
-
Mmantrid replied to the thread Drove through 2 feet of water, next day, clunking/sputtering when turning left/right slowly?.Well boys, this is cool, okay so I replaced the throttle body the other day as I'd took the old one off and it was ****ing oil at the motor section and the bottom of it was covered in thick oil. I couldn't get one side of the EGR pipe lined up...
-
MHi all, I was just looking into manifolds for a 2010 discovery 4 tdv6 3.0 (Not sure if I need one yet) and I came across these... https://maltings4x4store.co.uk/inlet-manifolds/allmakes-4x4-3-0-sdv6-aluminum-left-hand-inlet-manifold-lr179200/...
-
Mmantrid replied to the thread Discovery 4 - Limp Mode Cold Start Manifold absolute pressure issues.I know but I replaced the throttle body and took it for a days drive to my dads and no ticking, I get back, I spray this egr stuff and THEN the ticking starts, I suppose the intermittent but not extreme rattling of the engine when spraying in the...
-
Mmantrid reacted to Yorkie57's post in the thread Discovery 4 - Limp Mode Cold Start Manifold absolute pressure issues with Like.
A "tick" is also a sign of manifold failure.
