Recent content by malcolm bell

Hi. Av seen you have done a body lift on disco 1 a while back. Could you please tell me about the steering column. I removed one bolt on the bottom of the straight piece. But after doing 2inch lift it doesn't look as if there is enough splines left. Any info would be appreciated.thanks.

Thank for reply. Will try the electric fan . so would I remove viscose all together or not. Or put fan the other side of rad.dont have any ac rad on. Many thanks.

Since I have changed my radiator for a larger alloy one the temperature is reading 3/4 on the dash. I know thermostat opens around 88degrees the clock is reading about that. Any body got any ideas. Don't fancy cooking it.

Has any one altered the roof gutters on there disco.

Any ideas anyone. The red led bulb has gone on my alarm on the clocks.the red one that flashes when armed. Looked every where but have no idea for part number anyone know. Thanks.

Has anyone had this happen to them.ignition keys in ignition engine off . Had left heater control set to blower. I was outside the truck and the heater started by its self. Jumped in turn ignition key and it went off.

Your driving along at say 50.and it sometimes just starts.but if left till next day it starts up and drives good .then abit later it starts all over again

Could someone please give me a clue what.this could be.driving along and it starts to judder and slow down .turn off.start and drives no bother.no warning lights on you can hear pump in rear making noise all the time.t has done this for a few days now. What could it be.

Could someone tell me if when my diesel fuel v e pump is off the engine does the shaft turn easely by hand or do you need a spanner.

I have a2inch spring lift fitted does any one know what size spacers on both propshafts. And would spring lifting blocks be any good.

Disco 1. 2inch lift blocks.are they any good.

Disco 1 . 2inch spring lift.does anyone know what size prop front back spacers should be.

Hi kevstar. Av done me front and back lights . Am on doing the manuel pump. So am looking at the gearbox now . Was there any awkward bits. Am i right in getting a r380 box.full clutch kit with flywheel and crank seal and spigot. Do i need to change the pedal box or just add the clutch...

I want to take out my auto box and put a manuel r380 in. Has anybody done it.please reply.