Recent content by madmicko793

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. M

    engine conversion 2.25 diesel to 300tdi

    your ok, thanks. i'm saving it as a job for summer because by then i'll have my garages built and i'm also putting disco axles on defender.
  2. M

    engine conversion 2.25 diesel to 300tdi

    hey, just after abit of info please if any one can help. i've just bought a c reg defender 90 2.25 diesel with a buggered engine an also a disco 300 tdi all working as a bundle as the idea isto swap the engine into the defender. i have been told that i need to modify the engine mounts, and the...
  3. M

    rolled disco, wont run part 2

    will it be the big end bearings. i'll give anything ago. i might look for a cheap 4x4 to get me through winter coz me vans and pickup are no good in snow. plus its winter and i need to be out hunting
  4. M

    rolled disco, wont run part 2

    it revved its bollox off and kicked out loads of black smoke, the oil burning. by the time i jumped out it cut off, it wasn't a sudden stop, it died out, then i tried startin her again but she was just knocking.
  5. M

    rolled disco, wont run part 2

    ok, thanks for your advice i will put a new timing belt on. there is only one bent push rod, the one nearest windscreen, i will replace all the rods though, i just need her to see me through winter, by spring i will have my garage built and i will completely rebuild her.
  6. M

    rolled disco, wont run part 2

    i'd like to say it aint so, but i have never been inside the engine before, and looking at the slightly bent push rod i wouldn't of thought that it would make so much clanking, i am just trying to rule out the big end bearings. will it just be the fuel pump that has slipped out of line or will...
  7. M

    rolled disco, wont run part 2

    my disco has a bent push rod, the one nearest to the windscreen. does this indicate that the timing is out as she wont start, and will a bent push rod make a clunking sound when trying to bump her, all started when i rolled her and she supped the engine oil through turbo. many thanks
  8. M

    300 tdi fan removal

    ok. thanks
  9. M

    300 tdi fan removal

    how does the fan on a disco 300 tdi come off. thanks
  10. M

    disco 300tdi, rolled it and now wont run

    just stripped her down and the pushrod nearest to windscreen is slightly bent
  11. M

    disco 300tdi, rolled it and now wont run

    she was on her side for approx 10 mins. then about 5 mins later i cracked her up to see if she would start as we were in the middle of nowhere
  12. M

    disco 300tdi, rolled it and now wont run

    ok, will do. could the timing of slipped and now everything is out of line. thanks
  13. M

    disco 300tdi, rolled it and now wont run

    is the engine buggered then or can she be fixed, thanks for your reply
  14. M

    disco 300tdi, rolled it and now wont run

    hi, could do with a few suggestions please. i rolled my disco over onto drivers side, we pulled it back over onto its feet. i started her up and she was running but abit of black smoke. i drove forward 6 foot and she revved her arse off and kicked out loads of black smoke, i switched key off but...
Back
Top