Recent content by m19lte

ive used this kind of thing before, used wynns and seemed to work fine-as stated after a good run for the additive to mix/work

Yea you can add me to the list aswell if ya dont mind, allways fancy'd toms farm, im in heywood ol10

I had the same problem with my locks, it was the plastic cam on the back of the drivers door lock had broken put a new (salvaged cam/lock) one on sorted !

I need a new battery for my 94 3.9 v8 would i be best with one of these numax ones or go of there recommendations ? :confused: dont need it for winching or anything, just want a decent battery for starting and running my vehicle

Yep had the same prob wiv my 200 only last week, i cut the connectors off and put some bullet connectors on (way to much wires) then undid the 2 screws at the front, under the rubber mat, pushed stereo in, then screwed it back up just !

Deffo k-seal

HA HA HA HAAA nice 1 again ratty :doh:

;)Nice 1 ratty-nice 1 hat man im not the only 1 that lives in the real world then! anyway i dint mention muds :confused:

Thinking of getting some insas on my v8 as i want some bigger tyres(and they are priced reosanable) How do they balance-any wheel wobble on motorway ?

not sure if ive done this right ! 1st time for everytin eh !

Sign in Contact Us | Site Map Categories Christmas Deals Advanced SearchBuySellMy eBayCommunityHelp ##1## Back to Search Results | Listed in category: Vehicle Parts & Accessories > Car Parts > Land Rover Watch this itemSign in or Register to...

cowm leasure (cowm quarry) whitworth- rochdale

Yes mate same happend to me a while back,you need a full hydraulics kitt as they are a sealed unit.Part no stc 000180(i think,check year)have a look on fleebay,easy to fit

Does anyone know where i can purchase the ird pinion oil seal from as mine has started leaking oil(not the o ring, the one after,near the pinion nut) is it a simple job as you need to undo the nut and strip the pinion to get to it (i think) ? 1.8k y2000

hi all, my ird has started to leak oil (slow drip) from the pinion housing o/ring, just wondered is this an easy job ? where to purchase the seal from as i was told you cant purchase these ? its a 2000 1.8k