Recent content by landy10
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Got the oil, air and fuel filters replaced, took out the front passenger seat and headlining. Got the washer jets working and taking it for mot tomorrow. Its been two years since it was last mot'd but its only done 150 miles since then.
Got a s/h headlining to go in once i foam the roof.
-
Im picking up one second hand from equicar.co.uk tis a reasonable price ;-)
-
Cheers guys. will try the camping foam
-
Decicded to start using the landy again but the grotty headlining had to go. Pickin up a second hand one from wolverhampton on friday.
Th equestion is this, given that its the condensation on the roof that ultimatley leads to the demise of the head lining has anyone tried applyin a coat of...
-
Yep standard rear drums just had to buy the wheel nuts and they went straight on.
Yes the cap stcks through the middle but it doesnt look bad.
Got the full set of alloys with brand new tyres for 50 quid about 4 years ago :D
-
Wots wrong with alloys on an H plate :confused:
-
Woohoo got the landrover taxed now after passing its mot so BRING ON THE SNOW!!!
-
Will keep you posted on its progress :)
-
Sent mine for Mot, only needs a small patch on the o/s/f rigger strip and clean back brakes and repair to battery box. Not bad for a 21 year old 77,000 mile defender :-)
-
I know where there is a Hplate 200tdi county in blue just going through its mot with 77,000 on the clock :-)
-
Just make sure yer vents are closed before you open the bonnet or you will be spraying your bonnet again
-
Think you will find yer fan isnae working and as you drive along the air is being pushed through into passenger side only as thats where the air comes in. If yer lucky you wont have to replace your heater motor but if you do there are loads of threads about it
-
Bet That left a few marks on his leather seats!!
-
Wonder if your fault is the cause of this?
BBC News - Car kills two women on pavement in Glasgow city centre
-
Feckin hell that must be the longest heater motor fix in history!
Dint we say it was fooked on the second of december and needed replacing??
Drill an eight part hole in the botom of the fan housing and a 3/16th hole in the intake cowl to let any future water ingress out, also lengthens the life...