Recent content by Landrovercz

Let me know what you want for the electric ariel

Hi thanks a lot for your time and advice ! I will try and use the iPhone and blow the photo !

Blue beasty Sorry to have to chase you round the forum but could you read my theard on pulled out the rod thank for all you advice today

If I found the fork to be all right could I put it together with out the clip ? How could I tell if the fork is all right ?

Can I put in a longer rod ? Is there any chance the rod could fall into the bell house ? I pulled to hard on the rod to get it out a bit and looking a the clip you can see by the different shades it was contacted before I pulled at it could that mean there is no hole ? Should I use a bar and...

If I found the fork to be all right could I put it together with out the clip ? How could I tell if the fork is all right ?

Not much German spoke here ! Can I put in a longer rod ? Is there any chance the rod could fall into the bell house ? I pulled to hard on the rod to get it out a bit and looking a the clip you can see by the different shades it was contacted before I pulled at it could that mean there is no...

Might have cause more damage than good ! Got a pear of pliers and pushed and pulled the rod trying to find out was the fork out of place ! But I have pulled the rod out ! It has a plastic holder which must of been holding it in place ! Any advise would be much appreciate as I am in Czech...

Might have cause more damage than good ! Got a pear of pliers and pushed pulled the rod trying to find out was the fork out of place ! But I have pulled the rod out ! It has a plastic holder which must of been holding it in place ! Any advise would be much appreciate as I am in Czech Republic...

Have removed slave cylinder and can touch the rod ,it is sitting about 10mm inside .should I try and pull it out and if so how ?

Thanks James

Jamesmartin thanks for your reply . Do you mean the slave cylinder at the gear box?

Jacked up the vehicle and got it out of reverse gear and low .looked at master cylinder rod and it looks fine , Bled the clutch at the gear box the pedal went down and then went hard again and still cannot be depressed down . Can anyone advise me on what action to take next .

Is there any other way of release clutch to take strain of the transmission or get it out of reverse gear ?

I have unhooked the trail but still can't get it out of reverse or low gear .