Recent content by Kurt Gustafson

Problem solved.... Went for the easy solutions first. Disassembeled the regulators and found that one of the "locking pins" was damaged. Some sanding and lubricating, and things seem to be alright...:) The air goes where i want it to go....

Hi folks!! New challenge in my 1996 defender... The Hot air duct i stuck open so the air stream is sent down to th footwell. In the humid norwegina weather thats very inconvenient. Do i have to disassemble the whole dash to get to it, or is there any other quikcfix......

I have some issues with the wipers on my 1996 300 tdi Defender. I have isolated the problem to be with the motor, since wipers move easy. With a little help (a knock from at screwdriver or little hammer) it starts and runs normally. Without help it will not start unless I turn to max speed...

My 1996 Defender with a 300 Tdi has recently awaken form a long coma... It starts fine, and idles perfect. The moment i depress the accellerator the engine loses power and dies. Any thougts on the reason and possible cure??

The source of my electrical problems are located. Its that blue plastic thingy behind everything in the dashboard... How do I get to it in a civilized way withi\out breaking the whole car apart???

During my travel around the defender this show UP.... whats it for? Is it Just another plug with no function

Where do i find the earth connection point for the wipers?? I Think thats the best place to begin.

Light switch was changed yesterday.. No change:(

Uppdate: The problems seem to centered around the wiperswitch or related to the wipers. When the switch is connected everything fu... up. When disconnected things go back to almosts normal. Pity I sold my spare wiper switch last week.

Happiness is short lived. Electric trouble this time... started a few days ago when i turned on the headlights. The wipers started also.... indicators works fine in the rear, but not in the front. The problems Come andre go and i dont understand where to start. Many points out the blue...

I removed mine by cutting it to pieces..... and cut the old bolts with an mini angle grinder. A bigger challenge will be fitting the new one.

Time to do some electrical work now..... These cable bundles seem to grow by the time...

Its alive!!!! After a pretty violent break in to get to the solenoid, and some improvised cable work the engine fired up..... Quite happy now!!! The rest is just quality time..;)

Breaking into this is almost impossible.... but i guess thats the point. I have removed the plastic cover, but how do i cut the bolts without damaging the pump. Anglegrinder is a bit overkill :):) Any tips??

Ok guys.. starter relay works with extra ground. Starter cranks engine, but no diesel. I suspect faulty cut off solenoid an have a new one. But how to get to the solenoid? Its covered by a sort of plastic/metal cover that has three wires running into it. Is there any way of getting to the...