Recent content by Josh!

Hey, I had it set to coils last week for a few days of peace from the beeping. It registers no fault codes whilst in coil configuration at all. I will do so again tonight Photo above is the exact fault. It becomes historical as soon as ignition is switched off.

It’s back :mad::D

Hey, Continuity perfect on all 3! I have however reconnected the spare SLABS ecu and driven around 5 miles with no faulting - I will keep an eye on it over th coming days I’m wondering if one of the crimped connections was a little loose which I have resolved by doing a soldered joint and...

1. Yes brand new height sensor connector and wire wired directly into the 3 left hand sensor input wires about an inch before the ecu C0654 plug. 2. Same fault code, although the original ECU seems far more sensitive to this problem than the other different p/no spare I tried - ie. it faults...

Same code as before, LH power amp short to ground :(

Back at it! Disco still beeping it’s head off!! Another brand new sensor and no difference. Soldered the connections of the new wire as opposed to using bullet connectors I’d used initially. Still no difference, one thing I do notice is the constant beeping stops on a long right hand bend...

Right then, swapped to the spare ecu, I still get the fault but not nearly as much, I can drive for an hour or more and it won’t come on yet suddenly it bongs up, key off and back on and fault gone until next time! So I don’t think it’s ECU based really as the fault is still present although...

Hi all, hand my 2004 disco 2 for 3 weeks now and spent most of that fault fixing and getting oily! Also refitting air suspension which is a bit of a faff about but boy is it worth it for the ride comfort over springs!! I’ll stick around and hope to contribute where I can, this forum is super...

Ah that does make a little more sense. I figured there’d be a connector somewhere along the pipeline but couldn’t see it on any of the (simplified) diagrams I came across! The direct wire seems to have worked well in terms of stabilising the height sensor readings (before re wiring it was...

Hi thank you for the reply. From looking at the workshop manual etc the 3 wires go direct from sensor connector to SLABS ecu connector. I bought new OEM connectors and connected that to a length of 3 core 0.5mm2 wire ran along the chassis through the bulkhead then connected to pins 123 on...

Hi guys, Got a strange fault code that I can’t make sense of with my SLS. Basically, my 2004 discovery 2 XS had had coil springs retrofitted. I bought new air pipes, overhauled the compressor with new media and piston ring etc. new height sensors, contitech rear airbags then coded it back...