Recent content by johnk5707
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
J
yes I think it does, thanks
-
J
Hi All, can anyone tell me where the part in the picture goes?It was in the plie for the back door when I stripped my series 3 18 months ago but I cannot remember where it fits, TIA
-
J
Hi, I have just finished the rebuild of my series 3 with 2.2 diesel engine. When I started it up all was fine but once on the road the needle went into the red. It is not boiling up so I think it is electrical? I swapped the temp sender for another new one and it made no difference. Fuel gauge...
-
J
Hi it is a genuine safari roofed Landrover with the correct sliding side windows and alpine glass
-
J
These parts are left over from my restoration any suggestions where they go? I think it is to do with glass fitting
-
J
Hi, can I ask advice on what type of theft equipment can be fitted to my series 3? It has a steering lock which is poor and also the engine stop is cable into it. I really don't want a padlock on the bonnet if I can help it, TIA
-
J
I think I have worked out how to get pictures uploaded now
-
J
Hi I need help to identify parts that were removed from my land rover for its restoration. Not that good with computers so how do I upload pics? Thanks in advance
-
J
Thanks for telling me, but it is asked for on registration to this site. Should maybe be a general area like Tayside, but now amended Don't want it stolen
-
J
Thanks for the pic that is the same dashboard as mine
-
-
J
Thanks for the reply. That is the panel I have bought, but my dashboard seems different to the one in the picture. I will have another look
-
J
Hi I have bought a AUX switch panel for my series 3 but cannot work out where it fits in my dashboard any advice?TIA
-
J
Thanks for the reply Mine are rivetted onto the frame but the same seals . Just the new seals are very hard and push against the hinges and lock.
-
J
Hi, I hope I have posted this in the right section? I could do with a picture of the front door seal set up please. The set supplied is straight forward with lining up the rivet holes and fitting them, but it also came with a long length of rubber trim. Does this glue on to the new trim or how...