Recent content by joejoe300

Hi all could anyone spread some light on my fault please my air compressor is continuously running I put a new compressor to see if that was it still the same I then changed the front value block and its still the same any help would be much appreciated thanks

Yes I did the calibration I have just pulled the plugs on both front level sensors and read the voltage on pin 3 and 5 got 4.98 volts on both sides and it put two more codes up due to me unplugging the the codes was C1a03-1c C1a04-1c And the code that stays on C1a08-78 That's the code that stays...

Hi all just had a look at the voltage at the top of the dynamic strut tops on the front both read 0.88 volts Then I have done a ride level control module diagnostics interface And the following readings Left front corner height -103 Left front height sensor voltage 4.68 v Right front corner...

Hi did you get to the bottom of your problem

Hi thankyou for your comment yes I have made sure its fitted the correct way with the arm facing out I have deleted the code and it comes back up it's got dynamic suspension I got the suspension to go up when for a drive and the code came back up and it dropped the suspension

Hi all hopefully somone can help me I'm having problems with my suspension got a fault code c1a04-21 front left height sensor iv replaced the sensor with a genuine sensor and the fault still comes up it's a 2012 rangerover vogue l322