Recent content by Jays94RRC

It was easy to install took me about 2 hours with another pair of hands to help stretch the material and hold the headlining mould, just make sure that you clean off all the old headlining foam FULLY to avoid lumps in the finished headlining. I did not take the sunroof panel down as it was...

Here are a few pics of the headling replacement i did on Saturday, the cars almost finished just got to sort out the side mouldings, fit the silicone intercooler hoses and Wipac spots that are coming today.

Thanks for the comments yes i have put a lot of work into this most of which can not be seen (welding and repairs) and i am well pleased with the outcome. Thinking of fitting a light bar and some Wipac 8" spots on the bumper, bigger intercooler and silicone hoses. That should completely finish...

The colour does not match as my headlining was a dirty white colour, i sprayed the alarm sensors, light unit front and rear, sun visors and grab handles Satin Black from a spray can, gave them all 3 coats and came out perfect only took a couple of hours before they were dray and could be refitted.

It was New Grey, it matches the leather interior

Well its nearly finished, did the headlining today got the material from the same place Dopey said with the same spray glue from Ebay. Fitting it back in by my self was fun and doing the sunroof was even better!!! Fibre glassed the centre dash binnacle yesterday as it was smashed to...

I know they bolt through the rear floor to the mountings coming off of the chassis, i understand that bit but where do they run to each side and the lap belt and also around to each rear wheel arch? Just though with a few pics i could work it out, been through Rave that dont help and searched...

Hi all, has anyone got any pics of how the rest seat belts are installed including the lap belt. Thought I had taken pics then realised I didn't take them out someone else did who is now away. Any pics would be appreciated thanks

Does anyone know where the fuse or power comes from for the heated washer jets on the bonnet, just realised that i have no power to them, checked the connections back to the bulkhead etc, anyone got any ideas?

The wheels are standard Range Rover alloys that came with the car and i have seen them fitted to the last soft dash models. Just repaired the dents/scratches etc and sprayed them gloss black. Fitted new BFG A/T 235/70's. Not sure about the brooklands bumpers dont think it would have looked...

Done some more work on the car this week nearly there now, fixed the heating elements in both the front seats and refitted the carpet and seats back. fitted the bumper, new fogs etc, rear bumper etc. Fitted a stainless exhaust backbox as the original just looked crap with the whole cars image...

what do you mean by less reliable?

I found it!!, its for a rear upper tailgate central locking actuator, but my tailgate has not got one. So i guess thats one less thing to fix then.

Hi Does anyone know how the disable the alarm module/siren etc on a 94 Soft Dash so i can connect into the existing central locking wires at the control unit for a better alarm as the factory one is not going to prevent some one from nicking it! Im planning to fit an immobiliser/pager unit to...

I already have the wiring for the hi brake light that's the 2 black wires, and as for Rave i have that but cant make sense of the wiring and colours at the rear of the car