Recent content by innes1963

many thanks for Island 4x4, much better than the dull witted shop answer..

hi does anybody know where you can purcharse the upgraded RFR from?

Hi all, its a 4.6 hse. 1995 i did disconnect both the blue wire and the other group of wires. When i turn the key the whole engine lurches from the force of the torque from the starter motor but it wont turn over, but it was running 30 secs and lovely too i might add prior to disconnection of...

just done the key sync process and still nothing... gonna have to do some head scratching me thinks.... ive put my van battery across with jump leads ( huge battery!!) and still nothing. i think that should be as though the battery is connected directly to the rangie? am i right?

I have just charged the battery overnight, i think its a tonka toy dud battery anyway. ive put it back on this morning only to be met again with the same problem. If i didnt know better it sounds like a bad earth but apart from the battery terminal which is a good earth i havent touched any...

with every error message in history momentarily flashing up on the dash.. then it settles down. just put that down to normal rangie quirks..

Hi Johnny, yes i have 12.5 across the terminals. the key sync im not sure? the dash board comes alive when the key is in...

i have reconnected the Rf unit and I still have my clunk when i try to start it..

Hi all, yes it is a 4.6 1995 with the inevitable battery drain issues. i did some research and discoverd that a wifi signal can activate the becm unit so as advised ii disconected the RFR gizzmo in the boot and went to restart it after only to be met with a resounding clunk.. any ideas anyone?

hi every one.. I have a p38 1995 with electrical discharge problems.. after some research i discovered that it may be down to the RFR picking up a stray wifi signal.. I disconnected the RFR gizzmo in the boot and went to restart her only to be met with a resounding clunk!!! i have 12.5 volts...

Hi every body, my apologies for the breach of protocol was unaware of how the site worked... new member with a malfunctioning p38...