Recent content by Igor0077

Hey Guys, believe it or not: I’m finished. Hevac works like a dream. The shut down of the controller was just a poor battery. Like I said before: Thank you to everyone who has helped me through this journey. It has been a long trip and you never let me down. Unbelievable. A very special thank...

Hey Guys, this is all just unbelievable. Yesterday I double checked the motors and realized that the distribution motor is out of business. When did this happen? I don’t know. Anyway. I changed this one against another one, connected my controller and had a book symbol again. 🙄 Than I swapped...

True. But what else could be the issue? I will check tomorrow if there is power on the pins when forcing the motor. Keep in mind that the wrong motor works when I force the distrib motor. If we come to the result that we need to check the hevac controller, could you give it an overhaul with...

Like I wrote before I fist changed the motors when the trouble appeared. When this was not successful I was thinking that the brand new motors might have a problem and bought another brand new kit. So I have two new kits here. One is in the car, one is on my knees. I connected this one again now...

When I use Nanocom and go to “Utility “ and force the distribution motor the right blend motor is moving. When I force the right blend motor also the right blend motor is moving.

Good Morning Guys, did I ever tell you how thankful I am for your help? Yes? It was just not enough. Checked fuses and relais - all good. Checked ground and power on the white 8 pin connector- also good.

On another note: I can‘t find any ground! I didn’t check the motors with 9v recently but I did it on the long way to here one day. There the motors worked perfectly. Can do it again of course.

Hey Guys, the values I see on Nanocom are looking okay to me. Yes, have two controllers and both do pretty much the same (or should I say they don‘t?). I don’t find any power with key in position 0. I find between 3 and 5 volts in position 1.. I find between 3 and 5 volts in position 2...

Now I corrected the positions of the motors but my problem stays the same. Questions, followed by questions: Nanocom: If I go to „Inputs „ - „Switches“ everything says GND and this doesn’t change no matter which button on Hevac I press. Is this a sign for a damaged Hevac or what is this telling...

Okay, just checked with your connector-plan and it seems that I messed up the motors. Now suddenly everything makes sense. Datatek, thanks so much for your help here! Also many thanks to pwood and anyone else who spend some time to help me here!! Wishing you all the most beautiful weekend ever!

I had no idea that three is a connector layout section in rave - I'm learning, which is just great! Unfortunately I couldn't find the connector 253. But still great!!

Oh wow, that's a treasure for sure - thanks Datatek! On the photo of my plug, would you say port 1 is top left or bottom right?

Thank you so so much for your help pwood! But I'm afraid I still need some help. I found the attached diagram on Rave but I struggle on two points: - I have the following cable colors: white, brown, grey, black and red/black. Rave is talking about B,N,W,RB,S ??? - My plug looks like this...

So, after quite a while today I received a second hand controler from UK. Unfortunately my issue stayed the same. So, one simple question (hopefully): Which motor goes to which place? One is marked with blue tape and in my opinion this goes to top right position, yes??? And one more question...