IandiscoV8's latest activity

I did my passenger side the other week. Removed the airbag, drilled a hole to unscrew the duct, got angry with the air duct and finally got it out of the way. Cut the cable and re-solders the potentiometer. Reattached with a choc block and works...

Just read tour last post. I have similar issue it will not stay at ride height overnight. Needs calibrating

You could also try jacking the corner up, do not go too far just get the sensor moving and it may send a signal?

Have you tried cleaning the connector blocks with contact cleaner, worked with my off side rear sensor. If this does not work try a decent make one, I have genuine on the rear and copy front, fronts took ages to settle down. I still need to...

Hi Steve, Are you saying car is not recognising the part not communicating with it?

I bit the bullet and ripped - carefully removed the dash out last weekend and installed my new genuine Blend motors and the heating is working perfectly. No book symbol - first for me on a P38 DO NOT connect the blend motors before installing...

You only have to calibrate the suspension if the height sensors are changed but a quick going over the settings is a good idea at least. 😁

Height sensors have been changed front and rear Mark, i have only eyeballed it and inputted figures into Nanocom, It is 'doing the dance' when I switch off and start up, as my car is a rolling resto daily driver and other things have got in the...

Hi all, Update on my Suspension. Everything is working OK but... I think there is a leak drivers side front, I have not replaced the air springs yet. Rear air springs replaced and has transformed ride quailty. The car is driving perfectly fine...

To the rear of the front drivers side wheel. 👍

Hi Mark, I checked every where, the car was so cheap I did not even check, I checked it was on the slam panel and thats it! Passed MOT with no issues or advisories - which surprised me. I am not overly worried. Going to double check the chassis...

Hi All, been a while. I have been fixing up my 2002 4.6 V8 Vogue. While fixing the blend motors I took the dash out. When I replaced the dash top I have noticed the bukhead/windscreen VIN plate is missing. Previous owner had a new windscreen...