Recent content by IandelaMare
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
I
Thought I would post a reply as I finally got to the bottom of this having been down the rabbit hole.
I like to think I am a logical thinker and I use tools to diagnose thorny issues for my job. So it’s really annoying that I made a simple mistake which led to weeks of pain.
I first noticed an...
-
I
OK, that's good to know. I have read some research that an HG that blows around a cylinder rather than a complete failure can put more heat into the engine. Not sure why but given my running hot symptom came on unexpectedly I would say this is definitely a suspect. Thanks again!
-
I
Good to know, thanks. Did you get the weird symptoms I am getting?
-
I
Thanks all for your comments. I think it's looking like a head gasket on the way to failure. Going into Landie specialist in a couple of weeks so fingers crossed the head doesn't need skimming! Thanks again
-
I
Thanks again for your replies. The previous thermostat was working (I tested it) and still had the issue. The system has had coolant changed a couple of times - had the radiator plug off and waited for air to escape etc. so I think the system is bled OK. Not losing coolant so don't think it's an...
-
I
Thanks for your replies. The Rad is not that old. By new rad cap do you mean new cap on the header tank? How would this make a difference?
-
I
Has electric fan. No cowl. Thing is it was running fine for months and has just started with the issue. Original Defender 200TDI engine
-
I
Firstly, I know there are lots of threads on here about overheating. However, I have an unusual situation I can't get to the bottom of.
My Defender 90 200TDI has started running hot on the motorway. Around town it's fine, but when pushing hard it gets to 98 degrees C (I installed a VDO sender...
-
I
Hi,
Looking for some advice. New to Defender ownership. Love my Defender. However. Leaks.
I have a persistent rear diff seal leak. I have replaced the seal twice and have installed a new flange. I noticed recently that the axle breather was blocked completely so have replaced that but the seal...