Recent content by ianbrown00

Many thanks for the advice, a few jobs for boxing day then.

My Disco has the annoying habit of losing power if off roading, especially if climbing slopes, it then struggles to tick over for a few minutes, then its back to running perfectly until you try steep climbs of very rough ground again! I thought it was a fuel problem and replaced the fuel filter...

Thanks for the reply, It's an auto and its the same in low or high, it feel like its fuel starvation, but I can hear the pump priming on startup. Not sure what you mean by baffles in the tank? I've brimmed the fuel and it still does it.

I have a 3.9 efi that runs perfectly on the road, at any rev and when driven hard, but as soon as I head off road and try to climb slopes it misfires and cuts out! I have checked the tank and pick up on the pump, I have also changed the fuel filter, but still misfiring. Anyone got any...

Bottle of Forte ordered, I'll let you know how I get on. Thanks Ian

It's definitely diesel rather than oil smoke, it does lack power at low revs but drives fine once it get up to speed, hadn't thought of the turbo.

I have a 300tdi auto, now converted to manual. it has suffered from excessive smoking on overrun and to a lesser extent on drive when cold. I blanked the EGR, backed off the pump timing, changed air filter and cleaned the intercooler. Prior to converting to manual the smoke was far worse...

Can you tell me what size wheels and tyres you are using on the Freelander?

Just thought I'd put an update to the above problem. After many hours of trawling the internet, checking various suggestions I finally found someone with the exact same noise and symptoms. A phone call to Dave @ Ashcrofts to confirm and hey presto "Broken Flexplate" Box seperated, flexplate...

Checked out all but this suggestion, have you had experience of this before James?

Thanks for all the advice, I'll start with the easy, engine/gearbox mounts, then front pulley (had this on one of my 200tdi disco's) think too noisy for vac pump but will look and the very last resort, box off and torque converter. I'll let you know how I get on tomorrow.

This is no normal diesel knock, its like someone hammering on the chassis. depending on the depth of the snow here tomorrow, I'm going to get underneath and have a good look and listen. strange thing is that the knocking doesn't increase in speed with the engine revs and as soon as you get to...

I think it's gearbox, or more likely the flywheel/torq converter. Because its centre of the box and engine it's difficult to say for sure. The noise is like big end knock but as mentioned disappears completely at 900rpm, no vibration, and no loss of any power.

I've had a look through a number of post of a similar subject but not really answered the question, so was hoping someone out there might have an idea. 300tdi auto, 1997, makes a real knocking noise on tick over, but stops about 900rpm and there is a distinct reduction in the noise if you...

I think your right seems like a lot of hassle for little or no power. Is the rover transplant reasonably straight forward?