Recent content by hi_arshard

Great 👍 Thank you… this is a perfect explanation… now it’s clear. I should be looking for a ATB LSD.

So you mean this is how it works on D1 and live with it…! ?

Air-Locker or E-Locker does the job ? Tried to find the internet couldn’t find much infor ?

🫣

Thanks for the input. Any modifications/ upgrades can be done to get the power on both wheels in each axle at the same time? thanks, 🙏

Is it normal that the stuck wheel will not get power and the wheel which is on air keep spinning? Same behavior for front and rear axle. If this is the case in D1, what is the solution to get the truck back on track ?

Hello guys, Could you please give your feedback on the below, I doubt my diff lock is not working as expected, Got stuck in the sand and wheels spinning without traction (desert sand) diff lock on H-lock Dash lights come on as well. Spinning wheels with no traction, Rear left wheel and...

Sure… will do that, thank you.

Hi thank you for the input. It’s a NonCat, but when checked the MAF the reading shows as 1.8 I am unable to adjust the CO in the MAF as it comes sealed, didnt bother much on this, I should look for a MAF which can be adjusted if this is coz for erratic idle ? And as you commented, “You...

Vac advanced is new, hose is secured tight and there is a suction while checking with mouth. Also Stepper motor replaced Yet to check the voltage on TPS will do that. Pls advise how can I check the ignition timing? A timing light is required? My idle is 1000rpm or little higher. When I...

Hi guys, with reference to the above issue. Was thinking the issue with the stepper motor, I replaced the bypass valve ( stepper motor) there is no change, same issue is happening. Issue , only when stopping, the idle is erratic and it goes down and stalls the engine. As start again it’s okay...

Thank you for the reply. Sorry, What is a bobweight how do I check that ? My issue is I don’t feel the V8 power. and what else should I be checking for ? Thanks

Hello, I have replaced the Vacuum advance unit, now I want to test it if it is working correctly. When the engine is in start and when I give a hard suck to the hose connected to the VAU, I see a slight advance in engine rev. But when I cover the hose connector with my finger (the connector on...

How do I clear it? Rover gauge? As per the last text 2 weeks ago there was no fully code as per the Rover gauge. Thanks

Hello, It’s a Disco 1 V8 3.9L I am trying to tune up the base idle which is currently slightly more than 1000 RPM. I am trying to set the idle by blocking the idle bypass hose line both side and tuning the screw on the throttle body butterfly, while tuning the screw I can get the idle down...