Recent content by HARRRISON

Yes battery fully charged

Yes done crankshaft sensor tested all fuses relays ect ect ect

I took the ecu off then took to daniel at storm tuning for table testing and all good. Yes i can hear the pump which i couldn't before and done the purge process

Update i put previously its a 10p engine well its the 15p engine my mistake. ECU is all good all earthing points cleaned checked wiring all good new fuel pump new fuel filter new crankshaft sensor still not starting can anyone help please

Update had the nanocom on the landy and it wont read the ecu

Ok so if i get an ecu what will i need to do after as i assume it will need programming to the car

The battery is fully charged terminals are tight ill check the earth wires and what is fubar

Update i have taken the cps out and i think its this as ive just noticed my fuel preasure regulater is leaking and has been going directly onto the wiring so im of to get a new sensor, plug and wire

Ok thankyou i will take a look

A dont think this is the starting problem but does anyone know what the plug is for in the image as i cant find any dangling wires

Just an update the car when trying to start the eml and glow plug light comes on flashing on an off any adeas peeps

Ok thanks going to try the crank sensor 1st as a few people have said this

My friend has the lynx but its like with not even plugged it in

Hi am still new to this thread so if i have not posted this in the right place apologies Recently for the last few day my landy has been cutting out while driving the eml comes on then just cuts out i cant turn it of completely then start it back up straight away and all is fine but once its...

Ive checked that theres no oil on or in the red plug to the ecu