Glack Attack's latest activity

i am out of the country for three weeks but will check this once I am back and let you know how I get on. Thanks for all your help with this.

Yip - headlights on and all other lights. Everything works as it should, also the dash lights. I checked the voltage by using my multimeter and sticking the ends of the terminals of the white connector. Would that be right?

Checked the voltage at the switch, looks like 0V. Might try and take a supply from somewhere else. Any thoughts?

I will get round to checking the voltages this weekend hopefully. Might just have to bastardise the loom that I have and see if I can get it working some how.

The lighting harness isn't available as a separate part. Neither are the bulb holders, which are the same (or similar) to those used in some Fiats and Vauxhall Corsas. The only part of the lighting harness that's available separately, is the...

Didn’t even occur to me to check voltages, I will try that at some point. How would I go about rebuilding the loom? Just a new plug connector?

Good Evening everyone. I need a new wiring harness for the temperature slider controls area of the centre console on my 2013 Defender 90. There are 4 bulbs that currently don’t light up. Three of these lit up previously with a bit fidgeting with...

Hi again. Some more careful pro-ding/poking with a needle has done the trick. Thanks for your help.

Hi folks. I will try cleaning out the nozzle again and blow through the lines to see if this helps first and report back. Thankyou.

Hi, to replace the washer jet on a puma you have to remove the dash & the heater pipes. Had to replace the wiper wheel boxes on mine & the last thing you find is the washer jet so it is fitted first. You will need to strip it all out. But you can...

I do not know how to access it on a puma, on the older ones, they are very easy to swap over through the ashtray on the dashtop. If one jet is still working the other will just be blocked and some more careful pocking and prodding to clean is...

Hi, my puma did the same and I ran a small drill in ( I think it was . 75 mm ) and blew it out with an air line and it works fine now.

Hi Forum. One of the jets on the front windscreen of my 2013 Defender 90 Puma is not working. Reservoir is full of fluid, pump runs with no problems and one side does spray. I have tried cleaning out the nozzle with no luck. This has only...