Recent content by Gergely Bakity

Yesterday I found the problem. The problem was a fault cable to becm (C114-15pin) which measure the alternator charge voltage. Because of rust and corrosion sometimes the voltage signal drops to 7-8V. That's why BECM instantly shut off heaters. In this way another problem solved too, the...

Picture from my Landy!

Today I double check the air con request line cabling and measure the GEMS input and output pin.

Hello! Sorry: Front heated screen Rear heated screen Left Right seat heaters

Hello everyone! My Range Rover P38 (GEMS 4.6 95') got a strange HEVAC problem. When engine running I cannot switch on front, rear and seat heaters, but when engine not running everything works fine. With faultmate the only (current) error message: Air condition request line fault I had...

Just a small update the gearbox works well!

Problem now solved. It was a mechanical problem in automatic gearbox. Yesterday I take off the whole engine-gearbox-transferbox. After I diassembled the gerabox rear part, I found that the gear which is responsible for shaft speed losen from the shaft and freely rotate. I find the the 2 losen...

New error when I remove the igniton key from lock, the selector light won't go out, still remains red on the correct gear. Next week I try to get a working ecu, becuse it's not a healty. Had anyone got the same problem?

Hi Henrik! Have you checked the IACV (idle control valve). Clean valve and after base idle setup: http://www.roverparts.com/TechTips/Base_idle_setting_procedure.cfm Greg

Check the 3 Brown 12 V cables on BECM RH door side which is secured by 10mm bolts. In my P38 one had corroded and I have to change it from engine bay fuse box to becm. The another problem is BECM C113 connector (yellow) pin 2 which is send the sign to engine bay fuse box starter relay. If I'am...

Sorry I forget to publish the car specs: MY95' Range Rover P38 4.6 HSE GEMS

Hi everyone I need some help! The problem: Nanocom shows -> ANTI STALL FAULT (Invalid shaft sensor data) This is error is really the shaft sensor problem? After I clear the fault and go for a ride the transmission from 1st instantly change to 3rd and the above fault occurs immediately. The...

Hi everyone! I'm Greg from Hungary, past year I bought a Range Rover P38 4.6HSE GEMS MY95' the first, but the worst from the series but I 'still' love it. The car was is bad condition with every manufacturing defect, but I did my best with my friends: Full engine restoration with little tuneup...