Recent content by Gazza36

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. G

    Hi, sorry I did not reply to your message, I hope you got it sorted.

    Hi, sorry I did not reply to your message, I hope you got it sorted.
  2. G

    P38A Eas block rebuild now won't rise

    OK, many thanks.
  3. G

    P38A Eas block rebuild now won't rise

    Sorry, only just realised I had new replies, can you get just the dessicant or do you need to replace the whole unit? Thanks for replies.
  4. G

    P38A Eas block rebuild now won't rise

    I think mine was bits of vaseline, I won't be doing that again.
  5. G

    P38A Eas block rebuild now won't rise

    OK so fitted that o ring and up she went, still raised unevenly with the passenger side higher, levelled out after driving a little bit though. The dessicant had some broken bits in it, might replace it soon, many thanks.
  6. G

    P38A Eas block rebuild now won't rise

    When I took the block apart there was an o ring on the top of the diaphragm solenoid where the silver part meets the black base that screws to the valve block, now there was no replacement in the kit and when it was said that the diaphragm has no top o ring I think I have misunderstood what it...
  7. G

    P38A Eas block rebuild now won't rise

    It's the thin pipe above the exhaust filter that vents to the air, I had a feeling the air shouldn't be pouring out of there. I will have a look tomorrow. Cheers.
  8. G

    P38A Eas block rebuild now won't rise

    The piston seal is in position, could it be vaseline as the video suggested this to ease it in. It is a x8r kit. OK so air coming out of port 11 when the compressor is running which comes from the diaphragm block could suggest something wrong with the diaphragm.
  9. G

    P38A Eas block rebuild now won't rise

    Hi all, Sorry for posting the 1millionth eas thread Rebuilt the vavle block and compressor and now car won't rise at all. Output is not very good on compressor Took apart again, it contained lots of white bits Compressor runs continuously When compressor is running air comes out of port 11 Is...
  10. G

    P38A Juddering / squeaking

    It was the UJ, many thanks.
  11. G

    P38A Juddering / squeaking

    Many thanks, can you drive it with the prop removed?
  12. G

    P38A Juddering / squeaking

    Will do, many thanks.
  13. G

    P38A Juddering / squeaking

    Also noticed there was a lot of play in the UJ going into the front of the transfer box, don't know if that is relevant?
  14. G

    P38A Juddering / squeaking

    2000 W
  15. G

    P38A Juddering / squeaking

    Hi, driving without power. Just put a load of oil into the transfer box
Back
Top