Recent content by G-man

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. G-man

    labour charges

    all the this bloke does it for £650 is fine and dandy if you are near to him....if not you are going to have to get the vehicle to him, the link says £1.80 per mile so if you live in say bristol thats about 214 miles thats £385 on top of the cost of the clutch then you have to drive it home...
  2. G-man

    I'm going to be here. A lot.

    it could be you alterynator that is buggered or your clocks or your wiring but the first place to look is the connection on the back of the alternator
  3. G-man

    I'm going to be here. A lot.

    check the wiring on the back of the alternator ;) the speedo is cable but the rev counter is electronic off of the W terminal normally
  4. G-man

    Sankey Wide Track "Expedition" Trailer Build

    looks good :D definitely a lot less of a ball ache than my one is going to be lol
  5. G-man

    essex to bury manchestaaaaar

    nope..... still sitting in my yard lol
  6. G-man

    Indicators wont flash

    1.21 gigawatts.......great scott!
  7. G-man

    Netto veggie oil

    its like a cross between kwiksave, iceland and lidl....... the beans can be used as low cost ammunition
  8. G-man

    Netto veggie oil

    i went into netto once...it was an accident i thought it was the kebab shop entrance it took 3 weeks of flea treatments to get the itching to stop!
  9. G-man

    billing 2011

    might be if i have another landy by then
  10. G-man

    One off freelander..!!! You wont see another

    who dagged this fookin thread out of the gutter? ffs its a massive dog turd! from the badly fitted wonky mudflaps to the illegal blacked out rear lights..... but at least it wasn't done to a proper landrover
  11. G-man

    what the fook have i done

    two words....... avoid britpart
  12. G-man

    The Right Tools do anarf elp!!

    aye i spent years in a garage doing it, 2, 3 and 4 post ramps all the workshop equipment i could need... all owned by someone else.... now the only things i don't have are the workshop, a ramp, a bench grinder and a press the latter two are next in the pipeline on the big tools list of things to...
  13. G-man

    The Right Tools do anarf elp!!

    i do all my work on the floor and its a piece of cake if you have decent tools and jacks etc.....one of the best tools i have bought is the snap-on 1/2"drive cordless impact gun, blows all of the makita/metabo etc ones out of the water! battery lasts ages it'll undo normally tough bolts and...
  14. G-man

    why???

    i know someone who made one an what i think was a hilux or landcruiser chassis just for a laugh if i remember right it went quite well
Back
Top