Recent content by Fyrhawker

Ok so I’ve got the O/D rebuilt and trany all rdy to go back together. I have my gear box apart and the main shaft stripped. I see two pins in the shaft, one for the bush and the other for the thrust washer. The thrust washer has two notches in it for the smaller pin to line up with. Not...

Fixable or replace? Can I drill and tap these two posts out and maybe bolt it back?

I’m in Kansas, Winter is unusually warm and this is the second year of a drought. It killed the hunting season but now I have time to finish this thing up. My Synchro has two broken posts on one side. Has anyone every drilled/tapped them and bolted them back together? Good luck on that...

Evening guys, Update on my project. I haven’t straightened the frame as of yet. Will do that soon enough. The engine is back together and on the frame. Here are a few pics.

Evening all, I’m a little stuck on the engine re assembly. I can’t seem to find a decent exploded parts diagram of the engine to re install the Alt/Generator and I lost all of my tear down pics. Can someone please post pics of an installed generator and its mounting brackets? Thnx guys

No, my Plan didn’t work. It looks to me like the rear cross member (bumper) on the passenger’s side is lower than the other side. I’m trying to find a place to take it too locally.

Happy New Year’s Eve every one. Need a bit of advice. I was cleaning the engine and when I pushed on the threaded Heater Plug the center broke through. I’m not sure how to get this thing out now as it’s braking apart little by little. I’ve tried to find the part online along with instructions on...

Good evening everyone. I ran into a few snags today trying to identify the engine. Does this serial # 30700128A look right (2.25 petrol)? It’s stamped on the front left side of the block, just behind the water pump. I want to make sure I’m ordering the correct parts. As for the engine color...

Awesome info, Thnx. That should keep me busy for a while. Well my ingenious plan to straighten the chassis didn’t work out like I pictured it in my head. I guess it’s on to the next caper. Thnx again

Morning everyone, Well I think I’ve come up with an ingenious way to straighten my chassis. If all goes well and I live through it, I’ll post some pics. I should be able to start a mockup mid-week. Other than a reverse order does anyone have recommendations as to a proper...

Done

LOL, I knew some one would take advantage of that. Thnx James. Im about to head back out and see what else I can break. So far its been Knuckle skin.

Hello all, I’m Randy, I put where I’m from not where I live to throw off the thieves and assassins. Hope it works. Any ways I have a 70 Series 2A that I’ve completely disassembled and am just now rebuilding. I bought it from a friend who was planning on rebuilding it. He was...

I have a 70 Series 2A that I am rebuilding. I know the vehicle has been in a few fender benders so I’m not really worried about everything being perfect. I just got the frame back from galvanizing and I’ve got the springs and axles back on. I noticed that the rear member is about 1.5...