Recent content by Fuzzmeister
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
F
Hi Rob - thanks for the tip - I haven't replaced the G sensor (yet!). awaiting brake pedal switch and then I will test again. I use an Autel Unit (not sure what model it is but its a fairly good one (£1200 new although I got direct from Autel refurbished at £400). I also have access to a new...
-
F
Yeah I agree but its the second new one and I've swapped it with the osf sensor and that reads fine - still poor reading on the NSF.
-
F
Does anyone know if the wiring from the sensor goes in to the vehicle via a hole/grommet in the bulkhead or does it go straight to the ABS unit?
-
F
Hi - its a new sensor and bearing (had fault before these were replaced). I reckon there is a wiring problem from the sensor connection to the ABS unit. There isn't a reactor ring on this model.
-
F
Thanks mate:
Update: I cleaned the multi-plug at the ABS sensor which incidentally looks very clean with no rusty/corroded pins. I swapped the front sensors over and still have the fault at the NSF wheel - so with that done I can isolate the front sensors as being ok? I had a mates Snap-On...
-
F
Good thinking - I might try that.
Cost £18 delivered so cheap ones. Do they really make that much difference? I may have to buy a decent one but which brand then if not LR genuine.
-
F
Hi. Not sure if mine does that - I'll check but can't do til Saturday unfortunately.
-
F
Unfortunately ebay sensors - the NSF has had 2 now as I cut the wires on one to rule out the connector. The hub was thoroughly wire brushed and cleaned and the sensors seated properly. The bearing was OE.
-
F
C1016 - the main one that pops up - NSF wheel sensor.
0500 - Vehicle speed limit.
If I drive it for a while it says all the wheels have signal missing or too low.
All the sensors have been replaced.
I will clean the multi plug tomorrow - that sounds like it could be the culprit.
-
F
Ok - is this the one on the side of the ABS block on the OSF area of the engine bay?
-
F
Hi - it is the correct bearing. I checked and its the ABS type. It was picking up fine but the more I try to sort the fault the worse it gets! lol! Day after I fitted bearing the 3 amigos didn't come on for around 12 miles - now on all the time.
Yes - for sure. It worked fine directly after I...
-
F
Hi - it is the correct bearing. I checked and its the ABS type. It was picking up fine but the more I try to sort the fault the worse it gets! lol! Day after I fitted bearing the 3 amigos didn't come on for around 12 miles - now on all the time.
-
F
Hi from a newbie.
Freelander 1 Facelift 2005 3 dr.
Its a 3 amigos issues and I've read probably all of the threads on this and still have a couple of questions.
3 amigos on intermittently but now nearly all the time.
Ive replaced HDC switch which wasn't working but is now (2nd hand switch). Ive...
-
F
Hi - new to this forum as a member but have been using it to browse for years as its full of useful info.
Got a Disco 4 - love it when it works, much better than my Disco 3 which was forever breaking down. Got a Freelander 1 facelift as well - both are workhorses for my medical support business...