Recent content by frostythor

heated screen, full of wires that get hot...... but it was under the screen under the bonding check out the photo's in my post( Bad winter)

So Stanley is it a long breaker bar or a short one hahahaha

Had it years, as I use to do commercial trucks

Mot fast approaching so booked in for Friday, so I replaced a damages front door, (Banged up) the welded up the rust on my front windscreen (Bad Winter), only to get the 3 amigos for the first time, which the lead me to get a used Nanocom, from a Aeromole, replace the MAF sensor, and the air...

Got a nanocom thanks to a Landyzone member Aeromole who had just lost his TD5, and got a newer 4, sold me his now unwanted Nanocom, and they are all sorted now, but still fitting 2 new front hubs this week , and possibly new rear drop links then my MOT

I thought that was it then (A BAD WINTER) I had to do my windscreen welding just finished it new screen fitted and I got the 3 amego's for the first time in 18 years,

During the winter my screen started to crack and delaminate, on the driver side bottom of the screen, I put a bit of glass glue on it to stop it going all the way, anyway with the good weather and just finishing off the door replacement , I book a new screen I suspected it was rust that had...

So after working on my roof I went to pay my Bill when a lovely woman in her little Ford smacked me in the passanger door, it didnt look a lot but the door was dificult to close any way a quick search round and I and I managed to get a Scrap one decent colour match, so I thought thats it...

this is the mounting plate to remove them both in one go

this a drawing of the TC adapter plate

Hi removing the TC box and Clutch housing tegether as one makes it a very heavy unit, ther is an adapter plate you can use to remove the TC box separately, the

nice bumper whats the make

possibly this one Double Braid Metallic Hose 316l x 304L Nominal Bore (NB) Braid Layers Nominal OD (mm) Nominal ID (mm) Minimum Bend Radius (Static) mm Minimum Bend Radius (Dynamic) mm Max Safe Working Pressure (BAR) Max Safe Test Pressure (BAR) Nominal Burst Pressure (BAR) 1/4" 2 12 6.2...

why not go for stainless steel braded , high pressure hoses, https://www.intricoproducts.com/product/stainless-steel-convoluted-metallic-hose

Watch this, as before does the lever connect to the hi /low shaft