Recent content by freespaña
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
F
Hi, only say that I changed only the nozles of injectors.
My car jerked at about 2000 rpm. With the change (about €70 for 4) it works like new.
-
F
Very good job!!!!
Try to do the door cards, is not a difficult job and the result greatly improves the appearance of the car.
-
F
Oh! thank you very much!!!!
I thought about this option but thought it was crazy because no one else had done it and it seems like very little "drillable" space. Perhaps I will entrust the work to a workshop that will balance the cardan shaft for me. Thanks for your time!!!!
-
F
Hello, insist if I may, the importance of maintenance. Change the haldex fluid and filter if you haven't already. You will save on hassles.
Greetings.
-
F
Ok. I think the same, thank you very much
-
F
That support is for 3 doors and yours is 5 is not it? I looked for it and didn't find it. If it helps, I made a measurement and much stiffer... Good luck.
https://www.landyzone.co.uk/land-rover/what-have-you-done-to-your-freelander-today.199594/page-546#post-5015141
-
F
That hub in the photo is not the same... It looks like I'll have to remove the hub from the bearing but I don't have any tools for that and I'm afraid of damaging the bearing. Thank you very much for your support.
-
F
no, the transmission comes out but the hub is still in place
-
F
Temperature problems can also be caused by: poor fuel mixture, incorrect spark plugs, thermostat stuck closed or almost closed, old or incorrect oil, dirty radiator, clogged air intakes, etc.
-
F
you can see that there is no space... I thought about drilling the rear drum support to pass the bolt from behind but it is not possible because of the CV joint support and suspension arms
-
-
F
There is no space between the cube and the support!!! the screw does not fit. Do I have to remove the hub? how? Thank you.
-
-
F
Hi. Freelander 1 2004. Thanks for the answer. Really? only punching I can remove the broken stund?
Pardon my ignorance, but what is this replacement called?
I assume it will come out the back. Tomorrow I try. Thanks again.
-
F
Well, that's it, I've screwed up a rear wheel bolt, can some kind soul tell me if it can be done and how it can be changed (please in detail)? where to buy replacement? THANKS