Recent content by FreelanderStephen

Thought I should give an update! Success! On a very rainy cold weekend in October 2023, myself and old man took to the underneath of my Freelander.... Surprisingly, nothing really went too wrong? Seized ball joint on the lower wish bone... cut off and replaced full wishbone as some evidence...

Thanks both @andyfreelandy @Freddie17

Thanks both. @Freddie17 @Alteredtech I plan on removing/replacing both driveshafts and both hubs/wheel bearings as I will have both anyway. Can anyone give me any guidance on oil seals in the gearbox and IRD? I don't have the 'correct' tool to pull the drive shaft out, and so I could just...

Hi all - Diagnosing a serious vibration in my Freelander 1. Established that there is significant play in the N/S/F Wheel Bearing - So thats being replaced... Poking around for secondary issues and generally looking over, as there was quite a vibration in my gear stick also, (Looking for...

Separated! Spraying/soaking over a few days - chisel fully through the UJ and some firm hitting, bent the bolt but.... Et Voila. (New bolt 0.92p from LR) Had actually ground both of the brackets off the bearings due to perish-ment and easier access. Bearing puller then pulled both bearings...

Hi all, Changing carrier bearings on my propshaft, removed one half of the prop from the VC joint, but the other is proper stuck on... release agent and heat not done the trick yet... Any tips? Thanks, Stephen

@Nodge68 Would the below be the right parts? Slave - LUK510008310 Clutch - VLO834182 Flywheel - VLO836550 Seal - ELR702.994

Yep absolutely get it, well in a dreamy land, i want to keep it forever :D it will turn into something of a novelty later in life, but for now id like to use it a bit, apart from this clutch issue it seems to say to me its in a great condition mechanically, only bit of rust was replaced this...

Cheers mate, and no extra bits and pieces? Seen someone say before 1 £20 seal needs replacing during, and someone else saying something about the drive shaft? :?

@Nodge68, Is there any specialist tools i need to do the full replacement myself?

Thank you very much (y) :)

So missed info from me, i replaced the master cylinder once with an after market, and it fixed the issue until it didnt... Then replaced with an OEM, and it didn't even reduce the issue at all ::(

Good evening, Overtime my clutch starts to loose pressure, and the pedal moves further and further to the floor, until it will no longer disengage the clutch plates. The fix for this was bleeding every 3/4 months, then every 1/2 months, until it became weekly, then daily, then every trip. I...