Freddie17's latest activity

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  • Freddie17
    Have you read any codes from it?
  • Freddie17
    Freddie17 reacted to Anaconda's post in the thread Route planning & best methods with Like Like.
    We go to Wiltshire or West Berkshire on occasion if you fancy coming along. Usually post up in the Green lane section before we go.
  • Freddie17
    Freddie17 reacted to Hicap phill's post in the thread Route planning & best methods with Like Like.
    Update…. 3good days of lanes. We decided not to do strata as lots of bikes out on the Taffy Dakar. They warned us 1 normal lane had a landrover off the edge & rolled down the bank & been there a few days. We was able to miss the section...
  • Freddie17
    Freddie17 replied to the thread Freelander 2 Bonnet stuck open.
    Is it connected at the catch end? The fact that the handle is also broken suggests that perhaps it is being pulled too hard - which could suggest that the cables have stretched over time (needing more movement on the latch). If you replace...
  • Freddie17
    Freddie17 replied to the thread Freelander 2 Bonnet stuck open.
    Check that the release handle has returned correctly in the passenger footwell (as in it’s not stuck ‘open’)
  • Freddie17
    Freddie17 replied to the thread 1st time purchaser.
    It really depends what you want, but I think they sound a little expensive... maybe not if they are forecourt sales though, rather than private. Of course, it depends on the quality of them. Generally, the F1 is older but easier to work on...
  • Freddie17
    Ok - cup half full; My new fuel cap retainer has been on for over 6 months now and is showing no signs of wear at all 😁
  • Freddie17
    If the primary concern is mpg then get a fiesta? If you're using it because nothing else will do the job.. your worrying about 1 or 2 mpg???
  • Freddie17
    Freddie17 reacted to xDParis64's post in the thread Drinking Coolant / Head Gasket with Like Like.
    Well I for once have good news, means I'm a bit of a moron, but that isn't new information. I was removing the inlet manifold today when I noticed a stud was without a nut.... I asked if someone had taken it off to a resounding... no... That's...
Back
Top