I guess if ALL the wiring loom is there then its is a goer, replacement screen, hvac, relays. But if not, you could use a stand alone hws kit like you can get for defenders or make one up. Spare blank on the top consul might be suitable for the...
I've done that on the 110 and the 38 with no oil loss, couple of drips clinging to the shaft at worst, a rag on the floor and another to wipe the shaft as you withdraw it if your drive is nice.
There is a potentiometer in the pump top. I'm trying to remember what it looked like but I recall you can clean it. I think it might have some sort of ribbon cable that solders on one side in order to get it out and clean underneath it but I...
Had a bit of bad luck and then good fortune. Had work mens large van on driveway today and decided to reverse the P38 off passed it. Yikes caught passenger wing mirror on their side door handle and made a mess of the mirror. My fault no damage...
A tapered drift would likely pull that straight. On my 110 (same set up really) I knocked the drift in from the opposite side to where the bolt goes in, once it was lined up the drift protruded to far through for me to get the bolt in, I...
I did one at a time on the 110 but it still rotated a bit. A jack under the diff nose and a long tapered drift through the remaining bolt holes pulled it straight .it was a faff though and I've got a pit too, lying on your back would be a pita I...
Unbelievable!
that worked wonderfully with the press. It took less than 2 minutes and the bushes were out.
I thought too much about it.
Thanks to everyone for the support!!!