Recent content by flanne101

I disconnected the ronbox at the maf sensor but is there also another place it needs disconnecting. I just watched a video on youtube and noticed them plug sa connector and mention something about the fuel connector.

It actually seems ok now, no smoke when I put my foot to the floor and responive to the pedal. It was slightly faster with the maf uplugged but sounded awful and produced lots of black smoke.

I just fitted a new genuine bosch maf sensor and repaired the air intake temp sensor by fitting a new one and a new pipe. It is no longer smoking when I rev the engine but it does not seem to have the same quick response that it had with the maf disconnected. The horrible raspy noise that it had...

It is just a temp sensor.

I bought this to fix my air temp sensor wires. I just need to solder it to the old broken wires.

Done that thanks, It is very smoky now with the maf disconnected, but a lot more grunt on the pedal. Hopefully when I ft the Bosch maf and fix the air temp sensor that will fix the smoke issue.

https://www.ebay.co.uk/itm/126034795344 I just bought this one and will give it a try when it arrives.

Ok I just fitted a new air filter and un unplugged the synergy and connected the maf and it was awful with no throttle response.I unplugged the maf and with the synergy 2 and the with the maf unplugged it is very responsive to the throttle and probably better than when it was connected with the...

If I turn both switches off on the synergy is that the same as unpugging it .

The car is now pulling but all the grunt seems at low revs and if I floor the accelerator I get what I can only describe as a black smoke bomb from the back. It was on no 8 so I will try again later at no4 on the box.

If I were to buy a pierburg maf which one would I need to purchase to fit inside the housing thanks?

A cheap one from ebay not a genuine one. https://www.ebay.co.uk/itm/364184535320

Hi, my freelander is very slow pulling away from junctions, I just always thought it is a slow car but after googling 0-60 Realised it should be faster than my girlfriends car but it is miles slower. I have just changed the Maf sensor and not noticed any difference but I also noticed a small...

Took me around 20 mins to fix it with this once I had removed the plastic splash guard and I never removed the wheel. I thought I would post this as I bought 2 spanners before I found the correct one to use from amazon in the link provided. GEDORE Combination spanner, AF 24 mm, Extra long, 15°...

I'm new to 4wd and pulling a boat in reverse on the beach the front wheels started to bog down but the rear wheels looked like they had no power going to them .the prop is all still in place. I did press the hill descent button and this was activated whilst on the beach, I now know what this...