Recent content by evobilly666

Hi, I have checked the three fuses behind the glove box and the one 8n the engine bay. All have continuity and light a test lamp on both legs. The transmission control module is the only one I cannot communicate with. The pcm, tccm, abs module, dsc, sls and a few other modules all throw a code...

I can do that, although the fault existed prior to application of the grease

I'm not sure, it was recommended by automotive store. Either way, I have no communication with TCM when I had cleaned the contacts prior to trying the grease. Car was fine prior to stripping it for rear belt so it is something that I have disturbed.

L320 TDV6 2008 Have just replaced hpfp belt. Disconnected all the harnesses at the tccm and pcm to make access easier. Have put it all back together and lost communication with the tcm. All contacts for the three plugs on the tccm are clean and corrosion free. I have also cleaned them with...

Hi, as title really. I am looking for a set of +3" lift springs. I am aware of the problems associated with such a lift and people's different opinions on such a lift. Does anyone know of +3 springs with a similar spring rate to standard without going custom made. Car is a tray back 300 tdi

Hi, thanks, it has recently had 12 months rent in the windscreen so I assume it is still insured and can't be in too bad condition to tax for a whole year. Cannot contact the men in black, seem quite illusive. Anyone have their details? :-)

I am looking for a particular blue discovery 200 tdi. My dad had it from new in the early nineties and I would like to track it down for genuine reasons. If anyone knows of a vehicle fitting this description please notify me. Not after address or anything, just want to know how the old girl is

Think your self lucky lol. The Saxon Centre in Christchurch, I clear the barrier by about four inches but then it would hit the ceiling going down the ramp. Had to back up and go out the in!

I will post some pics over the weekend some time. Getting the mot is so rewarding after putting the effort in. Makes me really want to knuckle down and get my trayback finished

I recently acquired an M registered 300 tdi. It was in good mechanical condition bar a cam belt, good service and rear discs and pads. However it failed its mot mainly on rust. (Everywhere) I paid £350 for it, dragged it back to the workshop. The rear floor was replaced a year ago, but...

Big p&p site near romsey in Hampshire

Anyone going to bunny lane tomorrow? A few if us are going, be good to put faces to names etc

Ok, well finally got round to it, so here goes... The victim... The strip down... The big chop... Rear Bulkhead build... Hope that worked, but that is how i'm doing mine

Very nice build mate. I am building a trayback, i'm about a year in to the project, the body is still off the chassis. I Like the way you built the back end of the cab. I built a frame using 25 x 50mm box then fixed the sheet steel to that. i have used a sliding window from an LDV convoy...

Lol, thankyou kooky. I may advertise as a complete car first